aireRyder F0051 Manual de início rápido - Página 8

Procurar online ou descarregar pdf Manual de início rápido para Ventilador aireRyder F0051. aireRyder F0051 9 páginas. Original ceiling fan

Trouble Shooting Guide

If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation

or wiring. If you experience any faults, please check this Trouble Shooting Guide. If a problem cannot be

remedied or you are experiencing difficulty in installation, please call our Customer Service Department.

PROBLEM

1. If fan does not start:

2. If fan sounds noisy:

3. If fan wobbles:

4. If light does not work:

SUGGESTED REMEDY

1. Check main and branch circuit fuses or circuit breakers.

2. Make sure that the wall control is turned "ON".

1. Make sure all screws in motor housing are snug. (not over tightened)

2. Make sure the screws which attach the fan blade holders to the motor are tight.

3. Make sure wire connectors at the back of light kit. are not rattling against each

other or against the interior wall of the back of light kit.

CAUTION: Make sure main power is turned off before accessing light kit.

4. Check to be sure the light kit is secured on motor tightly.

5. Some fan motors are sensitive to signals from Solid State variable speed

controls.

6. Allow "break-in" period of 24 hours. Most noises associated with a new fan will

disappear after this period.

All blades are weighed and grouped by weight. Natural woods vary in density

which could cause the fan to wobble even though all blades are weight-matched.

The following procedures should eliminate most of the wobble. Check for wobble

after each step.

1. Check that all blades are screwed firmly into blade holders.

2. Check that all blade holders are tightened securely to motor.

3. Make sure that canopy and hanger bracket are tightened securely to ceiling

outlet box and outlet box is mounted firmly to ceiling joist.

4. Most wobble problems of fan are caused when blades are not in equal level. To

check the blade levels, select a point on the ceiling above the tip of any blade.

Measure the distance from the ceiling to the blade tip, to an accuracy of 1/8

inch. Rotate the blades until the next blade is in the measuring position. Repeat

measurement for each blade. If all blade levels are not equal, you can adjust

blade levels by the following procedure. To adjust a blade tip down, insert a

washer (not supplied) between the blade and blade bracket at the screw

closest to the motor. To adjust a blade tip up, insert washer (not supplied)

between the blade and blade bracket at the two screws farthest from the motor.

5. Interchanging two adjacent blades could redistribute the weight and possibly result

in smoother operation.

1. Check blue wire from fan to make sure it is connected to hot wire from supply wire

coming out of the ceiling.

2. Check for loose or disconnected wires in fan light kit.

PAGE: 8 / 9

171120