AgXcel Muller ISO Configuração de início rápido - Página 13

Procurar online ou descarregar pdf Configuração de início rápido para Equipamento agrícola AgXcel Muller ISO. AgXcel Muller ISO 17 páginas.

AGXCEL LIQUID SYSTEM FREQUENTLY ASKED QUESTIONS (FAQ) CONTINUED

Can affect the performance of your system check valves, not enough pressure and all your check valves may



not OPEN.

 High Pressure – RECOMMENDED – GX2 Electric = 25PSI GX5 Hydraulic = 70PSI

Too high of pressure can also affect the performance of your system as this can cause too much restriction in



the manifold tubes and too much resistance will slow the rate down.

 RULE OF THUMB FOR PRESSURE

AgXcel GX2 Electric systems = 15PSI – 25 PSI



AgXcel GX5 Hydraulic systems



For High-Speed Planters check out the AgXcel GX30i VRT Solution



How do I raise and lower my pressure when required?

 If your pressure is too HIGH then increase the size of your orifice and or Micro Tube to a larger hole size.

 If your pressure is too LOW then change the size of your orifice or Micro Tube to a smaller hole.

TIP - Many times the system may have difficulty priming, or if a flow meter has not detected flow and you

want the system to continue running so as to prime. Go to Diagnostics > Tests > Calibrate PWM Limits

1. Time for Auto Mode Testing

2. Once again, enter a Test Speed

3. Press the AUTO button

4. Ensure that the height switch is down or unchecked

5. Turn the Master ON

6. You can now monitor system flow vitals and ensure that all outlets of liquid are flowing

7. Once again, check sections if sections are being used

8. System testing is complete - Turn OFF the Master Switch

AgXcel System Performance Settings - To ensure the best performance of your AgXcel system especially at Start Up, setting the

PWM Start Up % can be fine-tuned. PWM Start Up % sends voltage to the pumps at the % that has been set. This can assist in the

priming cycle to get the pumps running quicker. Once the pumps jump up to the % set, then it will begin its cycle to lock into the

required target rate setting.

WWW.AGXCEL.COM

Quick Start Setup Instructions for Müller RCM ISO -

▪ Low Range = 15PSI – 40 PSI

▪ Medium Range = 20PSI – 50PSI

▪ High Range = 40PSI – 80PSI

Single Product

877-218-1981

Page | 13