IKEA IHW2530BS1 Instruções de instalação e manual de utilização e cuidados - Página 9

Procurar online ou descarregar pdf Instruções de instalação e manual de utilização e cuidados para Campânula de ventilação IKEA IHW2530BS1. IKEA IHW2530BS1 48 páginas. 30" (76.2 cm) wall-mount canopy range hood

Imprimir página

Install Range Hood

1. Remove screws from wooden shipping supports. Properly

dispose of shipping materials.

2. Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

3. Remove the grease filter. See "Range Hood Care" section.

4. Level the range hood and tighten upper mounting screws.

5. Install (2) 5 x 45 mm #2 Phillips lower mounting screws and

tighten. Use optional wall anchors if needed.

Connect Vent System

1. Install transition on top of hood (if removed for shipping)

with (2) 3.5 x 9.5 mm T10 sheet metal screws. Use T10

Torx

drive (or T10 adapter provided) to tighten.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over transition piece.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket using

(4) 4.2 x 8 mm T20

adapter provided) to tighten.

2. Measure from the bottom of the air deflector to the bottom

of the hood outlet.

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

3. Cut the duct to the measured size "X."

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over the

exhaust outlet from the hood.

7. Reassemble the air deflector to the duct cover bracket

with the 4 assembly screws.

8. Seal connections with vent clamps.

screws. Use a T20

Torx

drive (or T20

A. Assembly screws

B. Air deflector

C. Duct cover bracket

D. Vent duct

E. Exhaust outlet