ALIGNER CCD2.0WIFI Instalação e manual - Página 10

Procurar online ou descarregar pdf Instalação e manual para Equipamento de teste ALIGNER CCD2.0WIFI. ALIGNER CCD2.0WIFI 16 páginas.

4.4 Connection of sensors and internal devices of the detectors

The connections inside the detector are already made at the factory, so there is no need to open the

detector itself, except to replace components.

However, it is advisable not to remove the detector cover; in the event of malfunctions, it is preferable to

contact the manufacturer. However, when it is necessary to intervene for simple maintenance operations,

e.g. when replacing the battery, it is advisable to pay particular attention to returning the removed parts to

their original position.

Below is a brief description of the connections of the boards mounted on the detectors.

CPU 20624 board ‐ mounted on the FRONT "wireless" detectors with WIFI transmission

CPU board 20177 ‐ mounted on the REAR detectors:

JP100

Battery charger cable ‐ (*)

JP101

Battery charger cable (with serial cable also connected to JP300) ‐ Wiring code 18390

JP102

Battery Cable (where provided) ‐ Wiring cod. 14144 (label JP11)

JP300

Enclosure data connection cable (LOWER SIDE) ‐ Wiring code 18390

JP303

Convergence CCD signal cable ‐ Wiring code 18286

JP304

CCD alignment signal cable ‐ Wiring code 18926

JP301

Detector encoder signal cable (provided only on the rear right detector) Wiring code 18284

JP202

Keypad

JP200

Alphanumeric display (not provided on CCD2.0WiFi models) Wiring code 18282

JP302

Service connector

XP200

Programming jumper

The CPU 20624/20177 board is already integrated with the inclinometer device.

A detector equipped with the CPU 20624/20177 can be recognised from the FW version

which is 4.0 (or later) ‐ see chap. 6.1.

The CPU 20624/20177 can be updated with the FW or configured (as Left/Right

front/rear model type etc.) through the dedicated SW tool

the technical support site.

Page 8/14

Figure 14

note: this connector can be above JP101 or alongside JP102, depending on the board version

"F.Al.Co.", available on

R0368

Cod. R0368 ‐ rev.1.0

(03/2020)