Brother 884-B31 Manuais de operação - Página 10

Procurar online ou descarregar pdf Manuais de operação para Máquina de costura Brother 884-B31. Brother 884-B31 36 páginas. Cover stitch machine / top cover stitch machine

Imprimir página

Powering the machine

Turning on the machine

1. Insert the three-pin plug into the socket on the

lower-right side of the machine. Insert the power

supply plug into a power outlet.

2. Turn the main power and light switch <A> to "I"

mark (to "O" mark to turn off).

Operation

When the foot controller is pressed lightly, the

machine runs at a low speed. As the foot controller

is pressed further, the machine will increase

speed. When the foot controller is released, the

machine stops.

NOTE (For U.S.A. only):

Foot controller: Model KD-1902

This foot controller can be used on the machine

with product code 884-B30 and 884-B31.

* The product code is shown on the machine rating

plate.

Turning direction of

handwheel

The handwheel <A> turns in a counterclockwise

direction (direction of arrow). This is the same

direction as an ordinary home sewing machine.

Move the needles to their highest positions by

turning the handwheel so that the mark <B> on the

handwheel is aligned with the line on the machine.

Opening/Closing front cover

It is necessary to open the front cover when

threading this machine. Slide it to the right 1, and

then open it 2. After closing it, slide it to the left.

CAUTION

For your safety, make sure that the front cover is

closed when operating the machine.

Always turn off the machine before opening the

front cover.

Attaching/Removing a

presser foot

1. Turn off the main power and light switch or

disconnect the power supply plug.

2. Raise the presser foot lever 1.

3. Turn the handwheel 2 so that the line on

the handwheel is aligned with the line on the

machine. (See "Turning direction of handwheel"

in CHAPTER 1.)

4. Push the button on the presser foot holder 3 to

release the standard presser foot.

5. Raise the presser foot farther by pushing the

presser foot lever upward. Then, remove the

presser foot and store it in a safe location.

6. Again, raise the presser foot farther by pushing

the presser foot lever upward. Place the presser

foot just under the presser foot holder <A> so

that the groove in the bottom of the presser foot

holder <B> is aligned with the bar on the top of

the foot <C>, and then lower the presser foot

lever to attach the foot 4.

<A>

<B>

<C>