1.4.5 Additional Equipment Required
•
Antenna Sealant - Use antenna manufacturer's instructions, install according to FAA AC 43.13-2A.
•
Cables - The installer will supply all system cables including circuit breakers. Cable requirements and
fabrication is detailed in Section 2 of this manual.
•
Hardware - #6 Flat Head Screw (6 ea.) and #6-32 Self-Locking Nut (6 ea.). Hardware required to
mount installation rack is not provided.
•
Encoding Altitude Digitizer - Use encoding altimeter manufacturer's instructions, install according to
FAA AC 43.13-2A.
1.5
INSTALLATION APPROVAL
The conditions and tests required for TSO approval of the GTX 330 Transponder and antenna are minimum
performance standards. It is the responsibility of those desiring to install this transponder and antenna either on or
within a specific type or class of aircraft to determine that the aircraft installation standards are within the TSO
standards. For GTX 330 TSO compliance, see Appendix A. For antenna TSO compliance, refer to antenna
manufacturer's literature.
1.6
AIRCRAFT STATION LICENSING REQUIREMENTS
The Telecommunications Act of 1996, effective February 8, 1996, provides the FCC discretion to eliminate radio
station license requirements for aircraft and ships. The GTX 330 installation must comply with current transmitter
licensing requirements. To find out the specific details on whether a particular installation is exempt from licensing,
please see FCC Fact Sheet PR 5000 or contact the FCC at (800)-322-1117.
If an aircraft license is required, make application for a license on FCC form 404, Application for Aircraft Radio
Station License. The FCC also has a fax-on-demand service to provide forms by fax at (202)-418-0177.
The GTX 330 owner accepts all responsibility for obtaining the proper licensing before using the transponder.
Page 1-4
Rev. 1
GTX 330 Installation Manual
190-00207-02
Imprimir página