Brother HL-4570CDW Manual de configuração rápida - Página 19
Procurar online ou descarregar pdf Manual de configuração rápida para Servidor de impressão Brother HL-4570CDW. Brother HL-4570CDW 29 páginas. Printer
Também para Brother HL-4570CDW: Especificações técnicas (2 páginas), Segurança e legislação (21 páginas), Manual do utilizador (20 páginas), Manual (25 páginas)
Imprimir página
For Wireless Network Users
Configure the wireless
9
settings (typical Wireless
Setup in infrastructure
mode)
IMPORTANT
You must have the wireless settings you
wrote down for your network in step 8 on
page 17 before you proceed.
a
On your machine, press + or - to choose
Network and press OK.
Press + or - to choose WLAN and press OK.
Press + or - to choose Setup Wizard and
press OK.
When WLAN Enable? is displayed, press + to
accept. This will start the wireless setup wizard.
Otherwise press Cancel to exit from the
wireless setup wizard.
b
The machine will search for available SSIDs. If
a list of SSIDs is displayed, use the + or - key
to choose the SSID you wrote down in step 8
on page 17, then press OK.
If you are using an authentication and
encryption method that requires a Network
Key, go to c.
If your authentication method is Open System
and your encryption mode is None, go to e.
If your WLAN access point/router supports
Wi-Fi Protected Setup, WPS is available
appears. Press +. To connect your machine
using the automatic wireless mode, press + to
choose Yes. (If you choose No, go to c to enter
the Network Key.) When Press WPS on rtr
appears, press the Wi-Fi Protected Setup
button on your WLAN access point/router, and
then press + twice. Go to e.
Note
• It will take several seconds to display a list of
available SSIDs.
• If a list of SSIDs is not displayed, make sure
your access point is on. Move your machine
closer to the access point and try starting from
a again.
If you use your machine in an IEEE 802.1x
supported wireless network, see Using IEEE
802.1x authentication in the Network User's
Guide.
If your access point is set to not broadcast the
SSID you will have to manually add the SSID
name. For details, see Configuring your
machine when the SSID is not broadcast in the
Network User's Guide.
c
Enter the Network Key you wrote down in
step 8 on page 17.
To enter a letter or number, hold down or
repeatedly press the + or - key until the letter
you want appears, and then press OK.
To delete the letters you have entered, press
the Back key.
For more information, see Entering Text for
Wireless Settings on page 22.
Press OK when you have entered all the
characters, then press OK for Yes to apply
your settings. Go to d.
d
Your machine will now try to connect to your
wireless network using the information you
have entered.
e
A connection result message appears on the
LCD and a WLAN report will automatically be
printed.
If the connection failed, check the error code on
the printed report and refer to
Troubleshooting on page 20.
Wireless setup is now complete. A four
level indicator at the right of your
machine's LCD will show the wireless
signal strength of your access
point/router.
To install the printer driver, continue to
step 10.
®
For Windows
Users:
Now go to
page 23
For Macintosh Users:
Now go to
page 24
19