Kohler KD 500 Manual de oficina - Página 29

Procurar online ou descarregar pdf Manual de oficina para Motor Kohler KD 500. Kohler KD 500 44 páginas. 51267

Workshop Manual KD500 _ cod. ED0053029390 - 1° ed_rev. 00

ELECTRICAL EQUIPMENT

Starter motor: lh rotation direction (pinion side), 12V voltage

rating, power 1.1 kW.

Internal alternator: 12V - 280W

Voltage regulator: electronic, with controlled diodes and

indicator connection for battery recharger

Recommended battery:

In standard start conditions: 12V - 50Ah/255 A DIN

In heavy-duty start conditions: 12V - 60Ah/300 A DIN

Optional accessories: control strip with remote control switch

and OIL ALARM plant.

Illustration in fig. 42:

1. Ignition key - 2. Voltage regulator - 3. Starter motor - 4.

Battery - 5. Alternator - 6. Pressure switch - 7. Low battery

charge indicator - 8. Low oil pressure indicator.

CABLES: Colour x Section mm

CABLE COLOURS: B= white

M= brown

N= black

R= red

V= green

1. make sure that the connections between the regulator and

alternator are correct and in good conditions

2. detach the wire from the remote control switch from the

terminal and fit on a d.c. amperometer (A,fig. 43)

3. connect a d.c. voltmeter to the battery terminals (V, fig. 43)

4. make a few no-load starts or introduce a 80-100W lamp load

at the battery lugs to keep the battery voltage below 13V.

5. accelerate the engine to a 3000 rpm rate. The current

indicated on the amperometer must correspond to the values

in fig. 44.

6. disconnect the load (if any) and keep the engine at the

above mentioned rate for a few minutes. The battery voltage

must progressively increase until reaching about 14.2 V.

Meanwhile, the charge voltage must drop to a minimum value

of about 2A, with a speed determined by the battery charge

condition.

7. if charge current is missing or is less than the given values,

check the alternator and replace the voltage regulator if

necessary.

- 29 -