A-Tach Mounts 50116 Instruções
Procurar online ou descarregar pdf Instruções para Acessórios para automóveis A-Tach Mounts 50116. A-Tach Mounts 50116 2 páginas. Designed for ford transit connect 2019-20
Imprimir páginaA-Tach # 50116
Designed for: Ford Transit Connect 2019-20__
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
mount will attach into the two seams just behind
the top and bottom frame around the dash cubby
illustrated with the arrows in the photo.
(3) Remove the covering from the tape. Insert the
lower (Shorter) edge of the mount into the seam
next to the seam tool. Starting with a corner of the
mount will help to insert the edge.
See additional instructions on the back side.
ST-1
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
(2) Insert the thin edge of the seam tool into the
seam behind the frame around the dash cubby. It
is found under the rubber pad but the pad does not
need to be removed.
(4) Remove the seam tool and insert it into the top
seam just behind the frame around the dash
cubby.
A-Tach
Mounts