AVPro Edge AC-CXWP-KVM-KIT Manual de início rápido

Procurar online ou descarregar pdf Manual de início rápido para Extensor AVPro Edge AC-CXWP-KVM-KIT. AVPro Edge AC-CXWP-KVM-KIT 4 páginas. Hdmi & bi-directional usb extension kit with hdbaset technology

Imprimir página

ac-CXWP-KVM-kit

HDMI & Bi-Directional USB Extension Kit

Quick Start Guide

AVPro Edge's ConferX Dual Gang Wall Plate presents a Full 4k60 444 KVM solution

for anything from the home office to the classroom. Fully integrate with today's

interactive displays using bidirectional USB and ARC up to 40 meters over a single

category cable.

This guide will walk you through the following topics:

• Installation

• EDID Management

• Scaling

• Test Pattern Generator

• IR Control Signals

• RS232 Control Signals

• Audio Extraction

• ARC

• USB Extension

• Troubleshooting

installation

1. Install a CAT5e (or better) cable between the display and the source (be sure

to follow local low voltage code. This varies state to state).

2. The Tx has an HDMI input. Connect this to the output of the source with an

18Gbps HDMI cable

3. The Rx has an HDMI output. Connect this to the input of the display with an

18Gbps HDMI cable.

4. Both the Tx and Rx have an RJ45 HDBT connector. Connect each end of the

installed Category cable to these ports.

5. Install the TX Wall Plate into the dual gang box

6. Connect the orange 2 Pin Phoenix power supply to the RX, setting the RX POE

Switch to the "RX" Position

*NOTE - Only use the included power supply

EDID management/Scaling

The EDID Management Pin Wheel allows

you to manage the input device (typically the

display) to request specific video resolutions

and/or audio codecs from a source. EDID Pin

Wheel also allows for downscaling for use with newer sources and legacy displays.

HDB

T technology

with

ase