AVPro Edge AC-CXWP-MDP-100KIT Manual de início rápido - Página 4
Procurar online ou descarregar pdf Manual de início rápido para Extensor AVPro Edge AC-CXWP-MDP-100KIT. AVPro Edge AC-CXWP-MDP-100KIT 4 páginas.
When using projectors RGB is recommended.
Copying EDID From Output:
With 70-Kits
•
Connect category to TX/RX, HDMI to Display, and both RX and Display
are powered
•
Turn dial to F on wall plate
With 100-Kits
•
Connect category to TX/RX, HDMI to Display, and both RX and Display
have power
•
Turn dial to F on RX
Troubleshooting:
Having problems? Here are some general troubleshooting tips that may help:
(We recomend every integrator have the fox & hound troubleshooting kit. That way you
have a definitive answer when having problems with HDMI)
1. Try different HDMI cables. A defective HDMI cable can bring the entire system down.
2. If using short HDMI cables (.5m, 1m) try a longer cable. Some short HDMI cables do not
sync well.
3. Ensure you have the correct EDID settings selected.
4. Re-terminate the Category cable (even if a cable tester indicates that the cable is passing
signal).
5. Avoid RJ45EZ connectors
6. Check the Category cable length. It may be too long.
7. Remove any excess Category cable and be sure that it is not twisted or damaged.
8. If you are still having issues after troubleshooting, feel free to contact our Tech
Support department.
Have a question or need assistance?
Don't hesitate to contact us!
SUPPORT: +1 605-274-6055
USA TOLL FREE: 877-886-5112
EMAIL: [email protected]