Abatement Technologies HEPA-AIRE PAS600 Manual de instruções - Página 6
Procurar online ou descarregar pdf Manual de instruções para Purificador Abatement Technologies HEPA-AIRE PAS600. Abatement Technologies HEPA-AIRE PAS600 17 páginas. Portable air scrubber
Imprimir páginaELECTRICAL REQUIREMENTS
1. The PAS600s require a minimum of 110 volts AC, 60 Hz to operate properly; however, maximum air flow
performance requires 120 volts AC, 60 Hz.
2. Due to momentary start-up current surge, the unit requires a 15 amp circuit that is free of other loads.
3. Extension cords used for this unit must be UL-listed, heavy duty No. 14/3 AWG SJTW industrial grade 3-
wire type. Use of larger numerical gauge (lower capacity wire) power cord(s) may result in electrical
shock, fire hazards and/or damage to unit. The cord(s) must be in good condition and in continuous
lengths (no splicing) and should not exceed a total of 50 feet (15 meters) in length. Make certain that any
extension cords used do not reduce power to the unit to less than 110 volts. Use of a voltmeter to confirm
adequate voltage is recommended.
4. Check to ensure that any circuit to which the unit is connected is protected by a 15 amp circuit breaker.
The unit itself is equipped with a 12 amp circuit breaker.
5. The units should be connected to a three-prong, properly grounded electrical outlet equipped with a
Ground Fault Circuit Interrupt (GFCI) device. A GFCI is an electrical safety device that will trip the circuit
and stop the flow of electricity if leakage of current is detected.
Important Note: The GFCI on the PAS600 control panel only detects leakage of current from the unit or
an electrical device plugged into the GFCI. The PAS600 should be plugged into a GFCI receptacle at the
power source to protect the power cord and the unit. This GFCI will trip the circuit if it detects leakage of
current from the power cord or unit.
6. To avoid personal injury, fire hazards and/or damage to the unit's electrical system and power cord, do
not connect or disconnect the power cord to an electrical outlet unless the unit is switched to the "OFF"
position.
KEY COMPONENTS
4