Dell E04B Manual de referência - Página 12

Procurar online ou descarregar pdf Manual de referência para Servidor Dell E04B. Dell E04B 29 páginas. Bios and uefi

Imprimir página

View SATA Settings

To view the SATA Settings screen, perform the following steps:

Steps

1. Turn on, or restart your system.

2. Press F2 immediately after you see the following message:

F2 = System Setup

NOTE:

If your operating system begins to load before you press F2, wait for the system to finish booting, and then

restart your system and try again.

3. On the System Setup Main Menu screen, click System BIOS.

4. On the System BIOS screen, click SATA Settings.

SATA Settings details

About this task

The SATA Settings screen details are explained as follows:

Option

Description

Embedded SATA

Enables the embedded SATA option to be set to Off , AHCI, or RAID modes. This option is set to AHCI

Mode by default.

Security Freeze

Sends Security Freeze Lock command to the embedded SATA drives during POST. This option is

Lock

applicable only for AHCI mode. This option is set to Enabled by default.

Write Cache

Enables or disables the command for the embedded SATA drives during POST. This option is set to

Disabled by default.

Port n

Sets the drive type of the selected device.

For AHCI Mode or RAID Mode, BIOS support is always enabled.

Option

Model

Drive Type

Capacity

NVMe Settings

The NVMe settings enable you to set the NVMe drives to either RAID mode or Non-RAID mode.

NOTE:

To configure these drives as RAID drives, click System BIOS Settings > SATA Settings > Embedded SATA

Option and enable RAID mode. If not, you must set this field to Non-RAID mode.

Pre-operating system management applications

Description

Specifies the drive model of the selected device.

NOTE:

If no device is installed, it displays Unkown.

Specifies the type of drive attached to the SATA port.

NOTE:

If no device is installed, it displays Unkown Device.

Specifies the total capacity of the drive. This field is undefined for removable media

devices such as optical drives.

NOTE:

If no device is installed, it displays N/A.