Dell D825TM Manual de serviço - Página 13

Procurar online ou descarregar pdf Manual de serviço para Monitor Dell D825TM. Dell D825TM 33 páginas. D-1 chassis color monitor
Também para Dell D825TM: Manual de serviço (32 páginas)

Imprimir página

1. Color Monitor

Connect the communication cable of the connector located on the D board on the monitor. Run the service software and

then follow the instructions.

IBM AT Computer

as a Jig

D-sub

(9 Pin [female])

*The parts above (

Allow a 30 minute warm-up period prior to making the following adjustments:

Landing Rough Adjustment

1. Enter the full white signal.

2. Adjust the contrast to the maximum.

3. Input full green signal.

4. Moving the DY backward, and adjust coarsely the purity

magnet sothat a green raster positions in the center of

screen.

5. Moving the DY forward, adjust so that an entire screen

becomes pure green.

6. Adjust the tilt of DY, and tighten lightly with a clamp.

•

Landing Fine Adjustment

1. Place the set in the Helmholtz coil.

2. Enter a green signal only.

3. Degauss the entire screen with hand-degausser. Then auto-

degauss it.

4. Attach a wobbling coil to the specified position of CRT

neck.

5. Attach a landing adjuster sensor on the CRT.

6. Using a landing checker, adjust the DY position, purity,

tilt of DY.

7. Clamp the DY screw.

Clamping torque: 22 + 2 kgcm (2.2+ 0.2 N.m)

•

Convergence Rough Adjustment

1. All digital convergence data should be zero by MCP.

2. Enter the white crosshatch signal.

3. Adjust roughly the horizontal and vertical

convergence at four-pole magnet.

4. Adjust roughly HMC and VMC at six-pole

magnet.

SECTION 4

ADJUSTMENTS

1-690-391-21

A-1500-819-A

Interface Unit

mini Din

4 Pin

(8Pin)

) are necessary for DAS adjustment.

— 13 —

3-702-691-01

Connector Attachment

To BUS CONNECTOR

4 Pin

Convergence Fine Adjustment

Set DY four-pole magnet to mechanical center

before adjustment.

This should be prime mode.

NECK Assy

P.S Mg

6-pole Mg

4-pole Mg

Receive R.B. cross-hatch.

Adjust H.STAT and V.STAT at four-pole magnet.

4 Pole Magnet

D825TM

Mechanical

Set the

Center

finger

P.S Mg

XBV

CRT

1 +

R B