Dell PowerEdge M620 Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Interruptor Dell PowerEdge M620. Dell PowerEdge M620 23 páginas. Dell poweredge blade servers getting started guide
Também para Dell PowerEdge M620: Atualização da informação (38 páginas), Notas de lançamento (27 páginas), Manual (25 páginas), Manual de informações importantes (35 páginas), Manual de atualização (32 páginas), Manual de atualização (28 páginas), Manual do utilizador (26 páginas), Manual do utilizador (22 páginas), Manual de iniciação (12 páginas), Manual de iniciação (12 páginas), Manual técnico (46 páginas), Manual técnico (49 páginas), Manual da carteira (27 páginas), Manual técnico (44 páginas), Manual de iniciação (14 páginas), Manual de iniciação (12 páginas)

Imprimir página
Dell PowerEdge M620 Manual do utilizador
Dell -10GbE PTM
The PTM supports hot-insertion into the chassis. If the PTM is inserted to a powered chassis, the
power LED (green) should turn on immediately.

2.2.2 PTM Removal

The PTM supports hot-removal. It may be removed when the chassis is powered on or off.
The PTM must not be removed during a firmware update process.
Note: Firmware update is in progress when the Yellow LED is blinking.
2.3

Connecting the External Ports

The PTM front panel presents 16 SFP+ ports. Each port provides connectivity to a server with the
respective number. Figure 4 shows the front panel view of the PTM.
Figure 4: Dell 10Gb Ethernet Pass Through -k module Front Panel
D
D
10 Gb Ethernet Pass Through -k
D

2.3.1 10 Gigabit Ethernet SFP+ Modules

The PTM supports SFP+ modules for 10 Gigabit Ethernet, with 10GBASE-SR and 10GBASE-LR
PHYs. SFP+ modules must be approved for use with this PTM. Modules not approved may not
work. See Supported Cables and Media Types on page 19 for lists of approved Direct Attached
Copper cables (DACs) and optical modules.

2.3.2 Installation and Removal of Optical Transceiver Modules

Optical transceiver modules have a locking mechanism which can be opened or closed.
To insert the module into the cage:
1. Open the module's locking mechanism.
2. Make sure that the male connectors on the module aligns with the female connector inside of
the cage. Also check that there is no dirt or foreign matter in the module or in the cage.
3. Insert the module into the adapter card module cage.
4. Close the locking Mechanism.
To remove the module from the cage:
1. Unlock the locking mechanism by opening the handle.
2. Pull the module out of the cage.
Rev 1.0
9