Dell PowerEdge M710 Manual técnico - Página 23

Procurar online ou descarregar pdf Manual técnico para Interruptor Dell PowerEdge M710. Dell PowerEdge M710 31 páginas. Dell poweredge blade servers getting started guide
Também para Dell PowerEdge M710: Atualização da informação (38 páginas), Manual de atualização (44 páginas), Manual de atualização (21 páginas), Manual de atualização (14 páginas), Manual de instalação (7 páginas), Manual de atualização (1 páginas), Manual de iniciação (12 páginas), Manual de iniciação (12 páginas), Manual da carteira (27 páginas), Manual de iniciação (14 páginas), Manual de iniciação (12 páginas)

Imprimir página
Dell PowerEdge M710 Manual técnico
Dell™ PowerEdge™ M710 Technical Guidebook

sectiOn 11. stORaGe

a. hard Drive Overview / Description
The PowerEdge M710 supports 4 2.5" hard drives. These drives can be either SAS or SSD.
RAID 0, RAID 1, and RAID 5 are supported as long as a RAID card is included.

Hard Disk Drive Carriers

Hard drives must use the new Dell Hannibal drive carrier for 2.5" drives.

Empty Drive Bays

For the slots that are not occupied by drives, a carrier blank is provided to maintain proper cooling,
maintain a uniform appearance to the unit, and provide EMI shielding.

Diskless Configuration Support

The system supports diskless configuration with no storage controller installed in the system.

Hard Drive LED Indicators

Each disk drive carrier has two LED indicators visible from the front of the system. One is a green LED
for disk activity and the other is a bi-color (green/amber) LED for status information. The activity LED
is driven by the disk drive during normal operation. The bi-color LED is controlled by the SEP device on
the backplane. Both LEDs are used to indicate certain conditions under direction of a storage controller.
b. storage controllers
The PowerEdge M710 will support a variety of RAID cards:
• C ERC6 - The M710 supports this card with 128MB of RAID cache.

sectiOn 12. viDeO

a. Overview / Description
The PowerEdge M710 Integrated Dell Remote Access Controller 6 (iDRAC6) incorporates an integrated
video subsystem, connected to the 32-bit PCI interface of the ICH9. This logic is based on the Matrox
G200 with 8MB of cache. The device only supports 2D graphics. The video device outputs are multiplexed
between the front and rear video ports. If a monitor is connected to the front video connector, it will
take precedence over the rear connection, thereby removing the display from the rear connection.
The PowerEdge M710 system supports the following 2D graphics video modes:
ResOlutiOn
640 x 480
800 x 600
1024 x 768
1152 x 864
1280 x 1024
1280 x 1024
RefResh Rate (hz)
60, 72, 75, 85
56, 60, 72, 75, 85
60, 72, 75, 85
75
60, 75, 85
60
cOlOR DePth (bit)
8, 16, 32
8, 16, 32
8, 16, 32
8, 16, 32
8, 16
32
23