ALLNIC AUDIO D-10000 Manual do Proprietário - Página 8

Procurar online ou descarregar pdf Manual do Proprietário para Conversor de multimédia ALLNIC AUDIO D-10000. ALLNIC AUDIO D-10000 16 páginas. Digital to analog converter

Imprimir página

DO consider using a high-quality power cord, as well as inter-connects for both inputs and

•

outputs. The D-10000 OTL/OCL is a highly sensitive piece of electronic designed for neutrality

and will output what you put into it.

DO try to place the D-10000 OTL/OCL well away from major sources of RFI and EMI; though

•

well shielded, the D-10000 OTL/OCL will function best away from large power transformers

and other sources of such interference.

B. POWER CONNECTION

The D-10000 OTL/OCL DAC uses a standard three prong male IEC connection for AC input on the

right hand of the rear of the unit's chassis. You need a power cord with a female three prong IEC

connector at one end (See Figure 1).

The D-10000 OTL/OCL will be set internally for your location's electrical system characteristics.

Please check the setting for electrical input on the label on the rear of the unit to confirm that

your D-10000 OTL/OCL matches your location's electrical system. For North American customers,

the D-10000 OTL/OCL is set internally for AC 110/120 volt – 50/60 Hz. For customers in other

regions, the unit is set for 230/240V – 50/60 Hz operation. There is no way to change to another

AC setting.

C. INPUTS

The D-10000 OTL/OCL DAC has the following inputs (See Figure 1):

One optical ("Toslink") digital

•

One USB (Type B)

•

One AES/EBU digital

•

Two (2) coaxial digital (RCA)

•

The inputs may all be connected at the same time. To select the input you want to play, rotate the

knob on the right of the D-10000 OTL/OCL's front panel clockwise and counter-clockwise (See Figure

2), or use the appropriate part of the remote control (See the section "The Remote Control" below).

The D-10000 OTL/OCL utilizes a non-PLL digital receiver for lower noise. To avoid introduction of noise

and/or connectivity issues, the user should be sure to use high quality digital sources and cables that

meet applicable standards for the selected input (e.g., AES/EBU, S/PDIF).

D. OUTPUTS

The D-10000 OTL/OCL is equipped with one pair of unbalanced or "single-ended" (RCA) outputs and

one pair of true balanced (XLR) output connections. Each output pair is oriented horizontally. WHEN

FACING THE REAR OF THE DAC (See Figure 1), the:

XLR and RCA output connections are to the left of the IEC power connection;

•