ABB ACS880-01 Series Manual de instalação rápida - Página 10

Procurar online ou descarregar pdf Manual de instalação rápida para Equipamento industrial ABB ACS880-01 Series. ABB ACS880-01 Series 14 páginas. Industrial drives
Também para ABB ACS880-01 Series: Manual de instalação (20 páginas), Manual (16 páginas), Manual de instalação rápida e de arranque (17 páginas), Manual do utilizador (18 páginas)

ABB ACS880-01 Series Manual de instalação rápida
10 EN – Quick installation guide
Check the insulation of the input and motor cables and the
motor
Check the insulation of the input cable according to local regulations before
connecting it to the drive.
Check the insulation of the motor cable and motor when the cable is disconnected
from the drive. Measure the insulation resistance between each phase conductor and
the Protective Earth conductor using a measuring voltage of 500 V DC. The
insulation resistance of an ABB motor must exceed 100 Mohm (reference value at
25 °C or 77 °F). For the insulation resistance of other motors, please consult the
manufacturer's instructions. Note: Moisture inside the motor casing will reduce the
EN
insulation resistance. If moisture is suspected, dry the motor and repeat the
measurement.
DA
DE
ohm
ES
FI
FR

Connect the power cables

IT
See figures C, D,
1. Undo the two fastening screws at the sides of the front cover.
NL
2. Remove the cover by sliding it forward.
PT
3. Attach the residual voltage warning sticker of the local language to the control
panel assembly plate.
RU
4. Remove the rubber grommets from the lead-through plate for the cables to be
SV
connected.
5. Fasten the cable connectors (included in the delivery in a plastic bag) to the cable
TR
lead-through plate holes. Strip the cable ends. Slide the cables through the
connectors.
CN
6. Ground the cable shields 360-degrees in the cable connectors.
7. Connect the twisted shields of the cables to the grounding terminals.
8. Connect the phase conductors of the input and motor cables. Tighten the screws.
9. Units with option +D150: Connect the conductors of brake resistor cable to the R+
and R- terminals.
U1
M
V1
3~
W1
PE
E
and F. Use symmetrical shielded cable for motor cabling.