AQUATECH Sync Transmitter Housing Manual de instruções - Página 4
Procurar online ou descarregar pdf Manual de instruções para Acessórios para câmaras AQUATECH Sync Transmitter Housing. AQUATECH Sync Transmitter Housing 6 páginas.
Imprimir páginaInitial Setup
•
Additional Tools Needed: Flathead screwdriver,
Crescent wrench
•
Open SYNC Transmitter Housing
•
Then simply slide your transmitter into SYNC Hot
Shoe
•
Turn transmitter on, and lineup SYNC backplate
holes with SYNC housing
•
Insert Turn Knob from front of SYNC and thread it in,
spinning Turn Knob clockwise.
•
Remove the Flash Bulkhead plug from your Sport
Housing with a Flathead screwdriver turning counter
clockwise, install the supplied Flash Bulkhead onto
your Sport Housing making sure the two o-rings
are properly in place. Note: the additional Flash
Bulkhead will be found bagged with your grease,
hex key, Flash Sync Cable and camera hot shoe.
•
**Once the Flash Bulkhead is installed onto your
Sport Housing, attach the female end of the Camera
Hotshoe into male end of the Flash Bulkhead.
•
Once the Flash Bulkhead is installed attach the
female end of Camera Hotshoe into male end of
recently installed Flash Bulkhead.
•
Slide Camera Hotshoe into camera body.
•
Unscrew cap from SYNC housing Bulkhead and
housing Flash Bulkhead.
•
Remove caps from both ends of the SYNC cord.
•
Install one end of the SYNC cord into SYNC Housing
Bulkhead. Ensure it is correctly lined up by aligning
electrical pins.
•
Place the attached Sync cord Male threaded fastener
over the Female threaded Bulkhead and screw in
clockwise until secure.
•
Attach the other end of SYNC cord into housing
Bulkhead following the previous steps.
•
To install SYNC Flash Housing you will need to
have the Pro Mount installed. Please refer to the
corresponding manual for Pro Mount installation.
•
Push Quick Cam Mount through the slot on the Pro
Mount and securely screw into place.
•
Using the SYNC Transmitter Housing in and around
water
Using the SYNC Transmitter Housing underwater
For best results please make sure you have carefully
followed all initial setup instructions prior to taking your
SYNC Transmitter Housing underwater.
**After installing the provided additional Flash Bulkhead
onto your Sport Housing, please make certain it is
installed correctly by doing a "dunk" test (without your
camera installed). If there is any moisture or water
present after the "dunk" test is performed, please
contact AquaTech via [email protected] so we can
assist you with the reinstall of the Sport Housing Flash
Bulkhead. Note: when not using your Sync Transmitter
Housing, the supplied Flash Bulkhead cap must be
replaced. This Bulkhead is a "dry connector' and must
never be exposed to water. Either the sync cable or the
3