Aquatic AQ-BC-6BT Manual do utilizador e de instalação - Página 6

Procurar online ou descarregar pdf Manual do utilizador e de instalação para Leitor multimédia Aquatic AQ-BC-6BT. Aquatic AQ-BC-6BT 13 páginas. Hide-away media player for bluetooth audio & mp3 devices
Também para Aquatic AQ-BC-6BT: Manual do utilizador e de instalação (16 páginas), Manual do Proprietário (11 páginas), Manual do utilizador e de instalação (14 páginas)

Getting Started

1.7 Power On

The AQ-BC-6BT requires +12V DC to both the red and yellow wires. When both of these wires

have power the AQ-BC-6BT is always powered on, indicated by a red LED on the heatsink of the

media player. Ground is connected to the black wire.

In a spa application this requires the red and yellow wires to be jumped together and then

connected to the +12VDC output of the power source. In this set up the AQ-BC-6BT will always

be on, with a very low current draw when idle.

In a boat, ATV or other application requiring power from a battery, the yellow wire (constant

power) should be connected to the battery, and the red wire should be connected to the ignition

or a switch.

For detailed instructions you can check out our online video:

The optional remote AQ-RF-6UBT (sold separately) has a built-in Polymer Lithium recharge-

able battery and comes with a charging cable. Connect one end of the charging cable to the

charging connection on remote control and connect the USB end of the charging cable to

any USB charger (5V DC) for charging.

Make sure the remote has been charged before used.

The optional remote AQ-RF-6UBT (sold separately) should include the RF receiver (AQ-RF-

6UBT-R) and should already be paired from the factory. Plug the RF receiver into the remote

control 8-pin DIN connections on the BlueCube Media Player. If you need to synchronize the

remote, follow the steps below.

1. Make sure BlueCube Media Player is powered ON (red LED)

2. Put the remote within 0.5 meter of the BlueCube Media Player.

3. Press and hold MODE on remote control until the LCD shows "Pairing in Progress". Re-

lease the button.

4. Within 2 seconds, the LCD will show "Paired". If it fails to pair, the LCD will show "Retry

again". If this happens, wait 5 seconds and repeat steps above.

For any additional remote controls, you will also need to synchronize those remote controls to

the BlueCube Media Player.

If the pairing process is not successful, try again to put your remote close to the remote receiver or charge the remote

control if the battery is low.

Depending on the frequency of usage, the remote may drain its battery. Please charge the remote before use. If the LCD

shows nothing, the battery has been drained and will need charging.

If you have lost or damaged your remote control and buy a new remote control, follow the above steps to pair the

new remote control.

www.aquaticav.com

'How to wire your Aquatic AV stereo system'

http://www.aquaticav.com/support/videos

BlueCube Media Player AQ-BC-6BT