Olympus SZX16 Manual de instruções - Página 23

Procurar online ou descarregar pdf Manual de instruções para Microscópio Olympus SZX16. Olympus SZX16 36 páginas. Research high-class stereo microscope
Também para Olympus SZX16: Visão geral (24 páginas), Manual de instruções (28 páginas), Manual de instruções (40 páginas)

Imprimir página

8-2 Detailed Assembly Procedure

Fig. 16

Fig. 17

30°or less

Fig. 18

Installing the Pillar

1. Using the Allen wrench provided with the base, loosen the two clamping

screws @ on the pillar support sleeve completely.

2. Hold the pillar ² so that the Allen screwdriver storage hole comes cap at

the top, and insert the pillar into the pillar support sleeve until it reaches

the bottom.

3. Using the provided Allen wrench, tighten the two clamping screws @

securely.

Reserve Screw Holes

Two screw holes ³ (6 mm) are provided for use in mounting a manipulator,

etc.

Mounting the Focusing Assembly

1. First loosen the focusing assembly clamping knob @ completely and,

while holding the focusing assembly with both hands, insert the pillar ³

into the mounting hole ² from below. (Fig. 17)

# Insert slowly. Do not apply excessive force.

2. Lower the focusing assembly until it stops, then tighten the focusing

assembly clamping knob @. (Fig. 17)

To prevent the microscope from turning over, the focusing assembly

must be installed on the same side as the stage plate in the stand,

as shown in the illustration marked "\" in Fig. 18, and its pivot angle

must be limited to 30°. If the focusing assembly is placed on the

wrong side, the microscope will turn over.

# If the clamping knob @ is tightened while the pillar ³ is not completely

inserted into the mounting hole ², the plate spring supporting the

pillar will deform and the pillar will not be able to penetrate into the

hole. (Fig. 17)

SZX16

(Fig. 16)

(Figs. 17 & 18)