Axor Starck 10101XX1 Manual de instruções de instalação - Página 4
Procurar online ou descarregar pdf Manual de instruções de instalação para Mobiliário de interior Axor Starck 10101XX1. Axor Starck 10101XX1 16 páginas. Electronic faucet
Imprimir página
Installation notes
•
Flush the hot and cold supplies thoroughly
before installing the faucet. Damage to
the faucet caused by debris is not covered
under the warranty.
•
The hot and cold supplies should be of
equal pressure.
The faucet should not be used with a con-
•
tinuous flow water heater.
•
Do not install the faucet on a sink with a
raised edge.
•
Strong light sources should not shine di-
rectly on the sensor window of the faucet.
•
The faucet should only be used with the
battery pack or power pack supplied by
Hansgrohe. Do not attempt to use any
other battery pack or power pack.
•
The 110 V version of the faucet (models
10180/10185/10140/10145) requires
a 110 V electrical outlet installed by a
licensed electrician. All applicable local
codes must be followed.
•
The 110 V version of the faucet includes
a transformer that must be used. Do not
attempt to "hardwire" the faucet.
•
The faucet incorporates automatic range
adjustment -- the sensor automatically
adjusts itself to local conditions (lavatory,
brightness, etc.)
Do not bend or twist the supply hose!
4
•
The distance between the switch on/off
point to the faucet is approx. 6 1/4" - 8"
under normal conditions. The detection
area may be less for dark, non-reflective
objects, or greater for bright, highly reflec-
tive objects.
•
If the sink is very small or highly
reflective, follow the range reduc-
tion instructions on page 13. When
the faucet is in reduced range mode, the
LED in the sensor window will flash while
the faucet is not in use.
•
Drops of water or condensation on the sen-
sor window may cause the faucet to run.
•
If the LED in the sensor window flashes
while the faucet is in use, the battery is low,
but the faucet may still be used. If the LED
stays on, the faucet will not run, and the
battery must be changed.
•
If the power to the outlet or to the building
fails, the 110 V version of the faucet will
not run.
•
The spray pattern will be unattractive im-
mediately after installation or service, due
to air in the faucet. After the faucet is used
10 - 15 times, the spray pattern will clear.