ABB Series Manual do utilizador - Página 8
Procurar online ou descarregar pdf Manual do utilizador para Controlador ABB Series. ABB Series 12 páginas. Area controller
4
Communication Connections
Communication connections should be made with care. To avoid conflicts with existing networks, it is
recommended all communication configuration of the product be performed prior to connecting physical
media from the building automation system. Refer to Aspect Studio On-Line Help System for additional
information.
Caution: It is recommended that all software configuration be performed prior to physically connecting this to any
associated communication
ETHERNET NETWORK
Ethernet is a high-speed network layer widely used in commercial buildings. This product includes an on- board
Ethernet adapter, allowing users communicate with the device for product setup, as well as for building
automation routines and applications. The Ethernet network interface is located on the single board computer
card.
The on-board Ethernet network interface supports 10Base-T (10Mbps) and 100Base-T (100Mbps) Ethernet
connections. The product will automatically switch to 100Base-T operations if other devices and cabling
connected to the same subnetwork support this
CABLE TYPE AND LENGTH
Use an approved Category 5 (CAT5) Ethernet patch cable with RJ-45 plugs to connect the product to an
Ethernet switch or hub. Use professionally manufactured cables to assure reliable transmission rates and
connectivity between devices. Category 5 wiring is typically limited to about 100 meters (320 feet).
©ABB 2021 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
MATRIX Series |
product networks.
Figure 1-7 Standard Ethernet Connection Pinout
Communication Connections
8