Cisco 7000 and 7507 LED Board MAS-7KLED Manual de instruções de substituição - Página 10
Procurar online ou descarregar pdf Manual de instruções de substituição para Interruptor Cisco 7000 and 7507 LED Board MAS-7KLED. Cisco 7000 and 7507 LED Board MAS-7KLED 21 páginas. Front chassis panel and led board and replacement
Também para Cisco 7000 and 7507 LED Board MAS-7KLED: Manual (13 páginas)
Imprimir página
Removing and Replacing the Front Chassis Panels
Step 6
Step 7
Step 8
Step 9
This completes the chassis front panel removal and replacement procedures.
10 Cisco 7000 and Cisco 7507 LED Board Replacement Instructions
While holding the panel in place, place one palm against the top front center of the panel
to brace it, and place the other against the lip near the bottom edge of the frame. (See
Figure 7d.)
Push the panel upward and back into the chassis opening until the tabs on the front sides of
the panel are flush against the front of the chassis. (See Figure 7e.) You will have to use
significant force to compress the EMI shielding enough to fit into the opening. If the panel
resists, pull it slightly downward and make sure that the panel is lined up with the top and
sides of the opening in the chassis.
When the tabs on the front sides of the panel are flush against the sides of the chassis,
tighten the two captive screws in the bottom edge of the frame.
To replace the bottom front panel, place the ball studs on the back of the panel over the
holes in the front lip of the chassis and push the panel onto the chassis until the ball studs
snap into place.