Cisco NCS 4201 Manual de instalação - Página 24

Procurar online ou descarregar pdf Manual de instalação para Ponto de acesso sem fios Cisco NCS 4201. Cisco NCS 4201 42 páginas.

Installing and Removing SFP Modules

Follow these steps to remove and replace an AC power supply:

Step 1

Disconnect the power cord from the power source. Do not touch the metal prongs on the power cord when it is still

connected to the power supply.

Step 2

Remove the power cord from the power connection on the power supply. Do not touch the metal prongs embedded in

the power supply.

Step 3

Loosen the captive installation screw as shown in the figure below.

Figure 17: Removing the AC Power Supply

Do not use the captive installation screw or the power retainer to pull out the power supply.

Caution

Step 4

Grasp the AC power supply metal tab with one hand, and slide it part of the way out of the chassis. Place your other

hand underneath the power supply, and slide it completely out of the chassis. See figure Installing the AC Power Supply.

Step 5

Replace the AC power supply within 5 minutes. See figure Installing the AC Power Supply. If the power supply bay is

to remain empty, install a blank filler plate (Cisco part number 800-39165-01) over the opening, and secure it with captive

installation screws.

Installing and Removing SFP Modules

These sections describe how to install and remove SFP modules. The modules are inserted into the SFP module

slots as depicted in figure Installing an SFP Module without a Bale-Clasp Latch into an SFP Module Slot on

Cisco NCS 4201. These field-replaceable modules provide interfaces.

Cisco NCS 4201 Hardware Installation Guide

Installing the Cisco NCS 4201