Cisco WAP371 Manual de início rápido - Página 11

Procurar online ou descarregar pdf Manual de início rápido para Ponto de acesso sem fios Cisco WAP371. Cisco WAP371 15 páginas. Reboot and reset to factory default settings
Também para Cisco WAP371: Manual de início rápido (38 páginas), Manual (5 páginas), Manual (4 páginas)

Imprimir página
Cisco WAP371 Manual de início rápido
Because the factory default IP address configuration is DHCP, make sure
that your DHCP server is running and can be reached. You may need to
disconnect and reconnect the devices for them to discover their new IP
addresses from the DHCP server. You can then query the DHCP server for
the new IP address. See
Configuration, page 7
address.
If the wireless access points do not receive a DHCP response (there is no
DHCP server on your network) after 60 seconds, the access points will
fallback to the following default static IP address: 192.168.1.245 and a
default mask of 255.255.255.0. To reach that IP address, be sure that your
computer is on the 192.168.1.xxx network.
Rebooting the Devices or Returning them
8
to their Factory Default Settings
To reboot your device:
• If the Cisco WAP371 uses a power adapter, with the power on, use the
POWER button to reboot the device. The POWER button only functions
when the Cisco WAP371 uses a power adapter.
• When the power supply is PoE, unplug your Ethernet connection for
three seconds and plug it back in.
or
• With the power on, press the Reset button with an opened paperclip for
less than three seconds, or until the lights go off.
–
When all the lights go off, release the Reset button.
–
Release the Reset button as soon as the lights go off, or you will
restore the device to factory default settings and lose your
configurations.
To reset the device to factory default settings:
• With the power on, press and hold the Reset button with an opened
paperclip for more than 10 seconds.
–
All of the lights will go off.
–
Release the Reset button when the power light turns on.
Cisco WAP371 Wireless Access Point
Step 2
of
Getting Started with the
for more information on how to find the DHCP
10