Epson L200 Avisos e garantia - Página 7

Procurar online ou descarregar pdf Avisos e garantia para Impressora tudo em um Epson L200. Epson L200 12 páginas. Color inkjet printer
Também para Epson L200: Especificações (4 páginas), Manual de serviço (47 páginas), Manual do utilizador (4 páginas), Instruções (4 páginas), Começar aqui (2 páginas), Manual do utilizador (2 páginas)

Imprimir página

■

If you use an extension cord with the printer, make sure that the total ampere rating of the

devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make

sure that the total ampere rating of all devices plugged into the wall outlet does not exceed the

wall outlet's ampere rating.

■

Never disassemble, modify, or attempt to repair the power cord, printer unit, scanner unit, or

options by yourself, except as specifically explained in the printer's guides.

■

Unplug the printer and refer servicing to qualified service personnel under the following

conditions:

The power cord or plug is damaged; liquid has entered the printer; the printer has been

dropped or the casing damaged; the printer does not operate normally or exhibits a distinct

change in performance. Do not adjust controls that are not covered by the operating

instructions.

■

When connecting the printer to a computer or other device with a cable, ensure the correct

orientation of the connectors. Each connector has only one correct orientation. Inserting a

connector in the wrong orientation may damage both devices connected by the cable.

■

If damage occurs to the plug, replace the cord set or consult a qualified electrician. If there are

fuses in the plug, make sure you replace them with fuses of the correct size and rating.

■

Place the printer on a flat, stable surface that extends beyond the base of the printer in all

directions. If you place the printer by the wall, leave more than 4 inches (10 cm) between the

back of the printer and the wall. The printer will not operate properly if it is tilted at an angle.

■

When storing or transporting the printer, do not tilt it, stand it on its side, or turn it upside

down. Otherwise, ink may leak.

■

Allow spaces behind the printer for the cables, and space above the printer so that you can fully

raise the document cover.

■

Avoid places subject to rapid changes in temperature and humidity. Also, keep the printer away

from direct sunlight, strong light, or heat sources.

■

Do not place or store the printer outdoors, near excessive dirt or dust, water, heat sources, or in

locations subject to shocks, vibrations, high temperature or humidity. Do not use with wet

hands.

■

Place the printer near a wall outlet where the plug can be easily unplugged.

■

Do not insert objects through the slots in the printer.

■

Take care not to spill liquid on the printer.

■

Do not put your hand inside the printer during printing.

■

Do not touch the white flat cable and ink tubes inside the printer.

■

Do not use aerosol products that contain flammable gases inside or around this printer. Doing

so may cause fire.

■

Do not move the print head by hand; otherwise, you may damage the printer.

■

Always turn the printer off using the

power button light flashes. Do not unplug the printer or turn off the power at the outlet until

the

power button light stops flashing.

■

Before transporting the printer, make sure that the print head is in the home (far right)

position.

power button. When this button is pressed, the

Important safety instructions