Sony NSC-GC3 Manual de instruções - Página 29
Procurar online ou descarregar pdf Manual de instruções para Câmara digital Sony NSC-GC3. Sony NSC-GC3 36 páginas. Network sharing
Também para Sony NSC-GC3: Manual de serviço (15 páginas)
Precautions
Do not use/store the camera in
the following places
• In an extremely hot. cold or humid place
[n placcs such as in a car parkcd in thc sun. the
camera body may become deformed and this
may cause a malfunction.
• Under direct sunlight or near a hcater
The camera body may become discolored or
deformed. and this may cause a malfunction.
• [n a location subject to rocking vibration
• Near strong magnetic place
• In sandy or dusty places
Be careful not to let sand or dust get into the
camera. This may cause the camera to
malfunction. and in some cases this malfunction
cannot be repaired.
On carrying
Do not sit down in a chair or other place with the
camera in the back pocket of your trousers or
skirt. as this may cause malfunction or damage the
camera.
On cleaning
Cleaning the LCD screen
Wipe the screen surface with an LCD cleaning kit
(not supplied) to remove fingerprints. dust. etc.
Cleaning the lens
Wipe the lens with a soft cloth to remove
fingerprints. dust. etc.
Cleaning the camera surface
Clean the camera surface with a sofl cloth slightly
moistened with water, then wipe the surface with
a dry cloth. Do not use the following as they may
damage the finish or the casing.
• Chemical products such as (hinner. benzine.
alcohol. disposable cloths. insect repellent,
sunscreen or insecticide, etc.
• Do not touch the camera with the above on your
hand.
• Do not leave the camera in contact with rubber
or vinyl for a long time.
On operating temperatures
Your camera is designed for use under the
temperatures between O°C and 40°C C12°F and
104°F). Shooting in extremely cold or hot places
that exceed this range is not recommended.
; ' On moisture condensation
If the camera is brought directly from a cold to a
warm location. moisture may condense inside or
outside the camera. This moisture condensation
may cause a malfunction of the camcra.
If moisture condensation occurs
Turn off the camera and wait about an hour for the
moisture to evaporate. Note that if you attempt to
shoot with moisture remaining inside the lens. you
will be unable to record clear images.
i
To remove the built-in battery
On disposal of the camera, take the following
steps
to
remove the built-in battery
1
Make sure your camera has been
disconnected from the power source.
2
Open the "Memory Stick Duo" cover
(page 8) and loosen off the two screws
using a cross-head screwdriver.
3
Insert a flat-bladed screwdriver, etc., into
the groove
[A]
and lift the cover up in the
direction of the arrow until the cover does
not lower back down.
29