Cisco SCE 1000 and Manual de início rápido - Página 37
Procurar online ou descarregar pdf Manual de início rápido para Hardware de rede Cisco SCE 1000 and. Cisco SCE 1000 and 49 páginas. Service control engine 1000 2xgbe
Imprimir página
At the SCE 1000(config if)# prompt, type
Step 3
Enables auto-negotiation for the GBE interface.
Step 4
At the SCE 1000(config if)# prompt, type
Returns to Global Configuration Mode, from which you can enter the GigabitEthernet Interface configuration mode
for the remaining GBE port.
Repeat this procedure to configure auto-negotiation for the other GBE port interface.
Connect the GBE Line Interface Ports
Refer to Information About Cabling, page 35 to find the appropriate cabling diagram for the topology of your system.
Figure 18
Cabling the GBE Interface
PW R A
PW R B
ST AT US
MN G 1
MN G 2
CO NS OL
E
LIN K/
AU X
10/ 100 /
AC TIV E
LIN K/
100 0
10/ 100 /
AC TIV E
100 0
The following table presents the fiber specifications. The SCE 1000 may be ordered with either Multimode or Single Mode
transceivers The transceiver type is indicated on the front panel under the ports. Note that both transceivers on any individual
SCE 1000 are the same, either 850nm Multimode OR 1310 Single Mode.
Table 3
Fiber Specifications
SCE Model
SCE 1000 2xGBE MM
SCE 1000 2xGBE SM
Plug the specified fiber optic cable (see table above) into the appropriate GBE port on the front panel of the SCE 1000.
Step 1
Verify that the link LED is green.
Step 2
If the link LED does not light, try removing the network cable plug and reinserting it firmly into the module socket.
BY PA SS
C is c o S
C E 1 0 0 0
S er ie s
LIN K RX
2 x G B E
TX
LIN K RX
TX
RX
MM
TX
RX
MM
TX
GB E-1
SU B
LIN E
NE T
Transceiver
850nm Multimode
1310nm FRP laser
Single Mode
and press Enter.
auto-negotiate
and press Enter.
exit
Transmit Power
–9.5 to –3 dBm
–9.5 to –3 dBm
Receive Power
–17 to 0 dBm
–20 to 3 dBm
Typical (Max.) Distance
750m for 50µm Core
Diameter MMF
400m for 62.5µm Core
Diameter MMF
10 km for 9.0µm Core
Diameter SMF
37