Cisco TelePresence Server 7010 Manual de instruções de substituição - Página 11

Procurar online ou descarregar pdf Manual de instruções de substituição para Hardware de rede Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 23 páginas. 600w ac-input power supply and fan tray replacement
Também para Cisco TelePresence Server 7010: Manual de instruções de instalação (15 páginas), Manual de instalação (14 páginas), Começar a trabalhar (16 páginas), Manual de instruções de substituição (18 páginas)

Repeat Steps 2 through 4 for the left ear. The strip of mounting holes on the front of each

Step 5

ear should be approximately ﬂush with the end of the chassis. (See Figure 5.)

Figure 5

Installing the Ears on the Chassis

Lift the chassis and move it to the rack. Avoid sudden twists or moves to prevent injury.

Step 6

Insert the rear of the chassis into the rack, pushing it back until the ears meet the front

Step 7

mounting strips or posts on both sides of the equipment rack. Slide the chassis vertically

along the rails to align the mounting holes in the ears with those in the rack.

Step 8

From the front of the rack, insert all eight 10-32 x 3/8-inch, slotted screws (four on each

side) through the chassis ears and into the mounting strip. (See Figure 6.)

When all screws are inserted, use a 1/4-inch, ﬂat-blade screwdriver to tighten each one.

Step 9

This completes the rack installation. Proceed to the next section to install the cable management

brackets.

Cisco 7010 and Cisco 7505 Chassis Replacement Instructions

Replacing the Chassis