Cisco ASR 5000 Manual de instalação - Página 15
Procurar online ou descarregar pdf Manual de instalação para Porta de entrada Cisco ASR 5000. Cisco ASR 5000 37 páginas. Applying power and verifying the installation
Também para Cisco ASR 5000: Manual de instalação (18 páginas), Manual de instalação (33 páginas), Procedimento de instalação (8 páginas)
Imprimir página
Applying Power and Verifying the Installation
Color
Blinking
Green
None
PSCA, PSC2, PSC3 and PPC Card Standby LED States
The Standby LED on the packet processing card indicates that software is loaded on the card and the card is
serving as a redundant component. When the system first boots up, all installed packet processing cards are
booted into standby mode. You must then configure the system to designate which packet processing cards
are to serve as redundant components (in standby mode) and which are to function as active components.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 10: PSCA, PSC2, PSC3 and PPC Standby LED States
Color
Green
Blinking
Green
None
Description
Troubleshooting
Tasks or processes are
Verify that the Standby LED on a redundant packet processing
being migrated from an
card is also blinking green. If so, there is an issue with the packet
active packet processing
processing card that was active and is transferring its processes.
card to a
redundant/secondary
packet processing card
Card is not receiving
Verify that the Run/Fail LED is green. If so, the card is receiving
power
power and POST test results are positive. If it is off, refer to the
PSCA, PSC2, PSC3 and PPC Run/Fail LED States, on page 13
OR
for troubleshooting information.
Card in Standby Mode
Check the state of the Standby LED. If it is green, the card is in
standby mode. This is normal operation for the initial power-up.
Description
Troubleshooting
Card is in redundant
The first time power is applied to the system, all of the packet
mode
processing cards should be booted into the standby mode. This
is normal operation.
Tasks or processes being
Verify that the Active LED on the redundant packet processing
migrated from the active
card is also blinking green.
SMC to the
If so, there is an issue with the active packet processing card and
redundant/secondary
the system is transferring its processes.
SMC
Card is not receiving
Verify that the Run/Fail LED is green. If so, the card is receiving
power
power and POST test results are positive. If it is off, refer to
PSCA, PSC2, PSC3 and PPC Run/Fail LED States, on page 13
OR
for troubleshooting information.
Card is in Active Mode
Check the state of the Active LED. If it is green, the card is in
active mode.
Checking the LEDs on Packet Processing Cards
ASR 5000 Installation Guide
15