Cisco ASR 5000 Manual de instalação - Página 34
Procurar online ou descarregar pdf Manual de instalação para Porta de entrada Cisco ASR 5000. Cisco ASR 5000 37 páginas. Applying power and verifying the installation
Também para Cisco ASR 5000: Manual de instalação (18 páginas), Manual de instalação (33 páginas), Procedimento de instalação (8 páginas)
Imprimir página
Checking the LEDs on the RCC(s)
Color
None
RCC Active LED States
The Active LED on the RCC indicates that the card is being used. During normal operation, this LED is off
on both RCCs.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 30: RCC Active LED States
Color
Green
None
ASR 5000 Installation Guide
34
Description
Troubleshooting
Card powered with
Verify that the POWER LEDs on the PFUs are green. If they are
error(s) detected
not, refer to
troubleshooting information.
Verify that the power source is supplying ample voltage and
current to the chassis.
Verify that the card is properly installed per the instructions in
this document.
If all of the above suggestions have been verified, it is possible
that the RCC is not functional. Please contact your service
representative.
Description
Troubleshooting
Card is active
The RCC is actively routing traffic from a line card installed
behind a packet processing card that has failed to a redundant
packet processing card.
The RCC installed in chassis slot 40 processes traffic for the line
cards in chassis slots 17 through 23 and 26 through 32. The RCC
installed in chassis slot 41 processes traffic for the line cards in
slots 33 through 39 and 42 through 48.
See
12
Information on determining the cause of the failure can be found
in the System Administration Guide.
Card is not receiving
Verify that the Run/Fail LED is green. If so, the card is receiving
power OR Card in
power and POST test results are positive. If it is off, refer to
Standby Mode
Run/Fail LED States, on page 33
Check the state of the Standby LED. If it is green, the card is in
standby mode. This is the normal operating mode.
Applying Power and Verifying the Installation
Checking the LED on the PFU, on page 5
Checking the LEDs on Packet Processing Cards, on page
to determine which packet processing card has failed.
for
RCC
for troubleshooting information.