Cisco IC3000 Manual de instalação do hardware - Página 17
Procurar online ou descarregar pdf Manual de instalação do hardware para Porta de entrada Cisco IC3000. Cisco IC3000 37 páginas. Industrial compute gateway
Também para Cisco IC3000: Documentação do produto (12 páginas)
Imprimir página
Product Overview
Table 3:
1
2
For hazardous locations environments, if you are installing or removing the flash card or alarm wiring, follow
these warnings:
Warning: When you connect or disconnect the power and/or alarm connector with power applied, an electrical
arc can occur. This could cause an explosion in hazardous area installations. Be sure that all power is removed
from the device and any other circuits. Be sure that power cannot be accidentally turned on or verify that the
area is nonhazardous before proceeding. Statement 1058
Warning: Do not insert or remove the flash card while power is on; an electrical arc can occur. This could
cause an explosion in hazardous location installations. Be sure that power is removed or the area is nonhazardous
before proceeding. Statement 379
Caution: Use a ratcheting torque flathead screwdriver to torque the power connector captive screws to 5 in-lb
(0.6 N-m), the maximum recommended torque.
To install or replace the SD card, follow these steps:
1. On the front of the device, locate the door that protects the SD card slot. Loosen the captive screw at the
top of the door using a Phillips screwdriver to open the door.
Phillips screw
Door pivot point
Cisco IC3000 Industrial Compute Gateway Hardware Installation Guide
Installing or Removing the SD Card (Optional)
15