Installing the New Cartridge
Once you have removed the empty cartridge, you're ready to
install the new one. Follow these steps:
1. Remove the new ink cartridge from its package.
Caution:
You must remove only the yellow tape seal from the top
of the cartridge; leaving the tape on will permanently
damage it. Do not remove the clear seal from the bottom
of the cartridge; ink will leak.
2. Remove only the yellow part of the tape seal on the top of
the cartridge. Do not remove the blue label. (It's okay if a
bit of the yellow tape does not tear off.)
remove
black cartridge
3. Lower the ink cartridge into its holder with the blue label
facing up and toward the back of the printer.
4. Press down the ink cartridge clamp until it locks in place.
5. If you need to replace the other ink cartridge, remove it as
described in "Removing an Empty Ink Cartridge" on
page 8. Then follow steps 1 through 4 in this section.
6. Press the R cleaning button and close the printer cover.
Caution:
Never turn off the printer while the P power light is
flashing, unless the printer hasn't moved or made any
noise for more than 5 minutes.
The printer moves the print head and begins charging the
ink delivery system. The P power light flashes and the
printer makes various sounds. Charging takes about one
minute. When it's finished, you can print again.
color cartridge
Replacing an Outdated Ink Cartridge
If an ink cartridge is more than six months old, you may need
to replace it. How can you tell? You may notice that your
printouts don't look as good as they used to. If print quality
doesn't improve after cleaning and aligning the print head, try
replacing one or both cartridges.
Follow these steps to replace an ink cartridge before the
B black or A color ink out light is flashing or on:
1. Make sure the printer is turned on and not printing.
2. Lower the output tray and raise the printer cover.
Caution:
To avoid damaging the printer, never move the print head
by hand.
3. Press the E load/eject button and hold it down for a few
seconds until the print head moves to the left.
4. Pull up the ink cartridge clamp. The cartridge rises up from
its holder.
Warning:
If ink gets on your hands, wash them thoroughly with
soap and water. If ink gets into your eyes, flush them
immediately with water.
5. Lift the cartridge out of the printer and dispose of it
carefully.
6. Remove the new ink cartridge from its packaging.
7. Remove only the yellow part of the tape seal on the top of
the cartridge. Do not remove the blue label.
8. Lower the ink cartridge into its holder with the blue label
facing up and toward the back of the printer.
9. Press down the ink cartridge clamp until it locks in place.
10. Press the E load/eject button and close the printer cover.
Caution:
Never turn off the printer while the P power light is
flashing, unless the printer hasn't moved or made any
noise for more than 5 minutes.
The printer moves the print head and begins charging the ink
delivery system.
The P power light flashes and the printer makes various
sounds. Charging takes about one minute. When it's finished,
you can print again.
7/98
EPSON Stylus COLOR 640
EPSON Stylus COLOR 640
- 9
Imprimir página