aculab MC3 Manual de instalação - Página 17

Procurar online ou descarregar pdf Manual de instalação para Placa PCI aculab MC3. aculab MC3 19 páginas.

Imprimir página

Appendix D: Australia

Service Requirements

In case of equipment malfunction, all repairs should be carried out by Aculab plc. It is the

responsibility of users requiring service to report the need for service to our company.

Service can be obtained at :

AS/NZS 3548 declaration

This is a class B product. In a domestic environment, this product may cause radio interference

in which case the user may be required to take adequate measures.

No change or modification to the MC3 PCI card is allowed without explicit written permission

from Aculab, as these could void the end user's authority to operate the device.

Safety Warnings

Interconnection circuits should be such that the equipment continues to comply with the

requirements of TS001 for SELV circuits, after making connections between circuits using any of

the internal ports.

Installation and Safety

The following information regarding installation is provided for guidance only and does not

eliminate the need for competence on the part of the installer.

The card must be installed such that with the exception of the PCI bus and H.100 connections,

clearance and creepage distances shown in the table below are maintained between the MC3

PCI card and any parts of the host PC or other expansion cards which use or generate a voltage

shown in the following table.

Clearance mm

2.0

2.6

4.0

For a host or other expansion card fitted in the host, using

or generating voltages greater than 300V (rms or dc),

advice from a competent telecommunications safety

engineer must be obtained before installation of the

relevant equipment.

Clearance distances refer to the shortest distance between parts, measured through air. Creepage

distances refer to total distances measured across surfaces when installed in a normal office

environment. The creepage distances in parenthesis apply where the local environment within

the PC is subject to conductive pollution or dry non-conductive pollution that could become

conductive due to condensation.

Suite 702,

434 St Kilda Rd,

Melbourne,

Vic 3004

Australia

Telephone Number

Fax Number

Creepage mm

2.4 (3.8)

3.0 (4.8)

5.0 (8.0)

6.4 (10.0)

+61 (03) 9243 5585

+61 (03) 9821 5450

Voltage present on other parts of

the host or on expansion cards.

Up to 50V rms or dc

Up to 125V rms or dc

Up to 250V rms or dc

Up to 300V rms or dc

Above 300Vrms or Vdc

MC3 PCI Card Installation Guide