Motorola D1011 Manual do utilizador - Página 6

Procurar online ou descarregar pdf Manual do utilizador para Telefone sem fios Motorola D1011. Motorola D1011 30 páginas. Motorola d1010 series digital cordless phone with answer machine
Também para Motorola D1011: Manual do utilizador (35 páginas)

Imprimir página

3. Place the handset on the charger to charge for at least 24 hours. When the handset is fully

charged the

icon will indicate that it is fully charged.

4. When the handset is fully charged after 24 hours, plug the telephone line cord from the large

base into the telephone wall socket.

IMPORTANT

Warning! Use only rechargeable batteries. If non-rechargeable batteries are used WARNING BATT will

be displayed and charging will be stopped. Please replace with rechargable batteries.

BATTERY LOW WARNING

If the

icon flashes in the display, you will need to recharge the handset before you can use it

again.

During charging, the

icon will scroll in the display.

BATTERY PERFORMANCE

In ideal conditions, fully charged batteries should give up to 10 hours talk time or up to 150 hours

standby time on a single charge.

Note that new batteries do not reach full capacity until they have been in normal use for several

days.

To keep your batteries in the best condition, leave the handset off the base for a few hours at a

time.

Running the batteries right down at least once a week will help them last as long as possible.

The charge capacity of rechargeable batteries will reduce with time as they wear out, giving the

handset less talk/standby time. Eventually they will need to be replaced.

After charging your handset for the first time, subsequent charging time is about 6–8 hours a day.

Batteries and handset may become warm during charging. This is normal.

Setting up your D1010

Date and time

Providing you have subscribed to your network's Caller Display service, the date and time is set

automatically for all handsets every time a call is received.

The date and time is recorded with each answer machine message you receive.

If you do not have a Caller Display service you can set the date and time manually.

Set date and time manually

1. Press

and scroll

to CLOCK/ALARM. Press

2. Enter the date using the format

DD/MM

e.g.

3. Press

and enter the time using the 24 hour format HH:MM,

e.g. 14:45 for 2:45pm.

4. Press

to confirm or

to return to standby.

Your D1010 is now ready for use.

. Display shows

DATE &

TIME, then press

04/ 08

for 4th August.

Getting started