Whirlpool UXT4830AAW0 Instruções de instalação e manual de utilização e cuidados - Página 10
Procurar online ou descarregar pdf Instruções de instalação e manual de utilização e cuidados para Campânula de ventilação Whirlpool UXT4830AAW0. Whirlpool UXT4830AAW0 28 páginas. 30" (76.2 cm) and 36" (91.4 cm) range hood
Imprimir página
If using a vertical
round vent:
Attach round vent connector with 2 screws. Install a
round damper (purchased separately).
3.
Install the 4 - #10 x 5/8"mounting screws in pilot holes. Leave
about 1/4"(6.4 cm) space between screw heads and cabinet
to slide range hood into place.
\\\\\\\\\\
__
1/'4"
(6.4 mm)
For non-vented
installations
Check that the baffle plate has not been installed in the slot
behind the grille. If is has, remove the baffle plate.
A. Baffle plate
1.
Lift the range hood up under cabinet and determine final
location by centering beneath cabinet. Mark on the underside
of cabinet the location of the 4 keyhole mounting slots on the
range hood. Set range hood aside on a covered surface.
A
2.
A. Keyhole slot
Use 1/8"(3 mm) drill bit and drill 4 pilot holes as shown.
A
A. Drill pilot hole
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
4.
For Direct Wire Installations:
•
Install a UL listed or CSA approved strain relief.
A
A. UL listed or CSA approved strain refief
•
Pull about 12" (30 cm) of wire through wall or cabinet and
into opening.
For Power Supply Installations:
•
Follow instructions
included with power supply cord kit
marked for range hoods.
5. Using 2 people, lift range hood into final position, feeding
electrical wire through wiring opening. Position the range
hood so that the large end of the keyhole slots are over the
screws. Then push the hood toward the wall so that the
screws are in the neck of the slots. Tighten mounting screws
to cabinet, making sure mounting screws are in narrow neck
of slots.
6. Check that damper, if used, rotates up and down freely.
7. For Vented Installations
Only:
Connect ventwork to hood. Seal joints with clamps to make
secure and airtight.
10