Whirlpool WVU17UC0JW Instruções de instalação e manual de utilização e cuidados - Página 8

Procurar online ou descarregar pdf Instruções de instalação e manual de utilização e cuidados para Campânula de ventilação Whirlpool WVU17UC0JW. Whirlpool WVU17UC0JW 24 páginas. 30" 76.2 cm
Também para Whirlpool WVU17UC0JW: Instruções de instalação e manual de utilização e cuidados (24 páginas)

Imprimir página

Whirlpool WVU17UC0JW Instruções de instalação e manual de utilização e cuidados

6. Mark hole locations

Lift the range hood into place and insert the mounting bracket

tabs through the slots in the back of the range hood.

Hold the range hood firmly in place with one hand and bend

each mounting tab (A) upward approximately 90°.

Mark the hole at the power supply knockout (B).

OPTIONAL: Mark the hole in each mounting tab.

Remove the range hood and set it aside.

7. Mark and cut vent opening

7" (17.8 cm) Round Vent System

(2.5 cm)

Using the 7" (17.8 cm) round vent mounting plate, draw the

■

vent opening outline on the underside of the cabinet:

Place the vent mounting plate on the bottom of the

cabinet. Position the edge of the plate with the widest

distance (A) between the hole and edge of the mounting

plate against the wall. Position the side edges of the

mounting plate between the dots marked previously

IMPORTANT: The widest edge (A) of the vent

mounting plate must be positioned against the wall.

Trace the 7" (17.8 cm) vent opening (solid line) on the

cabinet bottom.

Using a jigsaw or keyhole saw, cut the vent opening

■

1" (2.5 cm) larger than the 7" (17.8 cm) hole traced

(dashed line).

8. Drill electrical opening

Using a 1

" (3 cm) drill bit, drill the hole in the dot marked

previously at the electrical strain relief.

OPTIONAL: Using a 1/8" (3 mm) drill bit, drill pilot holes for the

dots marked previously at each mounting tab at an approximate

45° angle in an upward direction.

9. Prepare Range Hood Vents and

Mounting Tabs.

Install Strain Relief

■

Install a UL listed/CSA approved 1/2" (13 mm) strain

relief (A).

Mounting Tabs

■

Start a #8-18 x 5/8" (4.2 x 16 mm) truss-head screw into the

mounting tab (F) on each side of the range hood as shown

in the inset. Insert the screws approximately 2 turns into the

mounting tab holes.

Non-vent (Recirculating) Installations

■

Using a #2 Phillips screwdriver remove the 2 screws and

remove the top, front rectangular vent cover (E). Go to

Step 12.

7" (17.8 cm) Round Vent Installations

■

Remove both top knockouts (C and D).