Zanussi ZDTS 102 Manual do utilizador - Página 11

Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar loiça Zanussi ZDTS 102. Zanussi ZDTS 102 16 páginas.

Imprimir página

• The appliance stops automatically.

• The audible signal for the end of the programme op-

erates.

1. Open the door.

– The end-of-programme indicator light comes on.

– The programme indicator light stays on.

2. Press the on/off button.

3. For better drying results, keep the door ajar for some

minutes before you remove the dishes.

Care and cleaning

Warning! Switch the appliance off before you clean

the filters.

Cleaning the filters

Important! Do not use the appliance without the filters.

Make sure that the installation of the filters is correct.

Incorrect installation will cause unsatisfactory washing

results and damage to the appliance.

To remove filters B and C,

turn the handle approxi-

mately 1/4 anticlockwise.

Fully clean the filters A, B

and C below running wa-

ter.

Remove the flat filter A

from the bottom of the ap-

pliance.

Let the dishes cool down before you remove them from

the appliance. Hot dishes are easily damaged.

Removing the load

• First remove items from the lower basket, then from

the upper basket.

• There can be water on the sides and door of the appli-

ance. Stainless steel becomes cool more quickly than

the dishes.

Put the filter system in po-

sition. To lock the filter

system, turn the handle

clockwise until it locks in

position.

Important! Do not remove the spray arms.

If the holes in the spray arms become clogged, remove

remaining parts of soil with a cocktail stick.

External cleaning

Clean the external surfaces of the appliance and control

panel with a damp soft cloth. Only use neutral detergents.

Do not use abrasive products, scouring pads or solvents

(acetone, trichloroethylene etc...).

Frost precautions

Caution! Do not install the appliance where the

temperature is below 0 °C. The manufacturer is not

responsible for damage because of frost.

If not possible, empty the appliance and close the door.

Disconnect the water inlet hose and remove water from

the water inlet hose.