Zanussi ZDTS401 Manual do utilizador - Página 13
Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar loiça Zanussi ZDTS401. Zanussi ZDTS401 20 páginas.
Imprimir página
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid dispenser.
3. Adjust the water hardness setting to the highest
level.
Select and start a washing programme
Set the washing programme with the door ajar.
The washing programme only starts after you
close the door. Until then it is possible to modify the
settings.
Do these steps to set and start a washing programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press the programme selection button again and
again until the digital display shows number cor-
responding to the required programme. Refer to
the chapter 'Washing programmes'.
4. Close the door.
– The washing programme starts.
When the washing programme operates, you
cannot change the programme. Cancel the wash-
ing programme
Setting and starting a washing programme
with delay start
1. Press the on/off button.
2. Set a washing programme.
3. Press the delay start button until the display shows
the necessary delay start of the washing pro-
gramme.
4. Close the door.
– The countdown of the delay start starts.
– The countdown of the delay start decreases with
steps of 1 hour.
– When the countdown is completed, the washing
programme starts automatically.
Do not open the door during the countdown to
prevent interruption of the countdown. When you
close the door again, the countdown continues from the
point of interruption.
4. Do a washing programme without dishes.
5. Adjust the water softener to the water hardness in
your area.
6. Adjust the rinse aid dosage.
Cancelling a delay start
1. Press and hold the Cancel button until the digital
display shows two horizontal lines.
– When you cancel a delay start, you also cancel
the washing programme.
2. Set a new washing programme.
Warning! Only interrupt or cancel a washing
programme if necessary.
Caution! Open the door carefully. Hot steam can
come free.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of inter-
ruption.
Cancelling a washing programme
1. Press and hold the Cancel button until the digital
display shows two horizontal lines.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme .
Fill the detergent dispenser with detergent before you
set a new washing programme.
End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
• The audible signal for the end of the programme
operates.
1. Open the door.
– The digital display shows 0.
2. Press the on/off button.
3. For better drying results, keep the door ajar for
some minutes before you remove the dishes.
13