Zanussi ZDTS401 Manual do utilizador - Página 4
Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar loiça Zanussi ZDTS401. Zanussi ZDTS401 20 páginas.
Imprimir página
1)
1) The indicator light is off while a washing programme operates.
Delay start button
Use the delay start button to delay the start of the
washing programme with an interval between 1 and 19
hours. Refer to the chapter 'Setting and starting a
washing programme'.
Digital display
The display shows:
• Adjusted level of the water softener.
• Activation/deactivation of the rinse aid dispenser
(only with multitab function on).
• Number corresponding to the selected washing pro-
gramme.
• Remaining time to the end of the programme.
• End of a washing programme.
• Number of hours in delay start.
• Fault codes.
• Activation/deactivation of the audible signals.
Multitab button
Press this button to activate/deactivate the multitab
function. Refer to the chapter 'Multitab function'.
Function buttons
Use the function buttons for these operations:
• To set the water softener. Refer to the chapter 'Set-
ting the water softener'.
• To deactivate/activate the audible signals. Refer to
the section 'Audible signals'.
• To deactivate/activate the rinse aid dispenser, when
multitab function is active. Refer to the chapter 'Mul-
titab function'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at the factory.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
4
Indicator lights
The indicator light comes on when it is necessary to fill
the rinse aid. Refer to the chapter 'Use of rinse aid'.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the
indicator lights of function buttons A, B and C start
to flash.
4. Press the function button C.
– Indicator lights for function buttons A and B go
off.
– Indicator light for function button C flashes.
– The digital display shows the setting.
The audible signals are activated.
5. Press the function button C again.
– The digital display shows the new setting.
The audible signals are deactivated.
6. Switch off the appliance to save the operation.
Do these steps to activate the audible signals:
1. Do the above procedure until the digital display
shows necessary setting.
Setting mode
The appliance is in setting mode when: .
• The programme selection indicator light is on.
• The digital display shows two horizontal lines (- -).
The appliance must be in setting mode for these oper-
ations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
– To deactivate/activate the rinse aid dispenser.
If:
• The programme selection indicator light is on.
• The digital display shows the programme duration
(in minutes).
Audible signals
deactivated
Audible signals
activated