Zanussi ZFT11105XA Manual do utilizador - Página 11

Procurar online ou descarregar pdf Manual do utilizador para Congelador Zanussi ZFT11105XA. Zanussi ZFT11105XA 16 páginas.

Imprimir página

min.

100 mm

15 mm

Door reversibility

WARNING!

Before carrying out any operations,

remove the plug from the power

socket.

CAUTION!

To carry out the following

operations, we suggest that this be

made with another person that will

keep a firm hold on the doors of the

appliance during the operations.

1. Tilt back the appliance carefully so that the

compressor cannot touch the floor.

2. Unscrew the left foot.

3. Remove the lower door hinge by

unscrewing the 2 retaining screws.

4. Remove the hinge pin from the bottom of

the door.

5. Slot the hinge pin into the hole in the hinge

plate.

6. Take the door off.

7. Refit the upper hinge pin into the opposite

location.

8. Fit the door in place on the hinge pin.

www.zanussi.com

9. Slot the hinge pin into the hole in the hinge

plate and relocate the hinge assembly to

the opposite location and refit using the

retaining screws.

10. Refit the bottom hinge plate assembly on

the opposite side, taking care that the edge

of the door is parallel with the side of the

cabinet.

11. Remove and install the handle (if foreseen)

on the opposite side.

CAUTION!

Reposition, level the appliance, wait

for at least four hours and then

connect it to the power socket.

Do a final check to make sure that:

• All screws are tightened.

• The magnetic seal adheres to the

cabinet.

• The door opens and closes

correctly.

If the ambient temperature is cold

(i.e. in Winter), the gasket may not fit

perfectly to the cabinet. In that case,

wait for the natural fitting of the

gasket.

In case you do not want to carry out

the above mentioned operations,

contact the nearest Authorised

Service Centre. The Authorised

Service specialist will carry out the

reversibility of the doors at your cost.

Electrical Connection

CAUTION!

Any electrical work required to install

this appliance should be carried out

by a qualified electrician or

competent person.