Zanussi ZCG43050WA Manual do utilizador - Página 8

Procurar online ou descarregar pdf Manual do utilizador para Fogões Zanussi ZCG43050WA. Zanussi ZCG43050WA 29 páginas.

Imprimir página
WARNING! Only a qualified and
competent person can do the gas
installation.
Before you connect te gas, disconnect
the appliance from the electricity
supply or switch off the fuse in the
fuse box. Close the primary valve of
the gas supply.
Supply piping should not be less than
R3/8. Connection is made to the Rc
1/2 (1/2 " B.S.P.) female threaded.
The entry pipe is located just below
the hob level on the rear left hand side
of the appliance.
The gas supply ramp is on the rear
side of the appliance.
WARNING! Only liquid sealants can
be used when the inlet gas pipe is
fitted i.e.: do not use the P.T.F.E.
sealant tape.
When the installation is complete,
carry out a gas tightness test and
make sure that the seal of each pipe
fitting does not leak.
Use flexible tubing, which comply with
the BS.669 current edition.
A
B
C
WARNING! The gas bayonet
connector must be in the marked area.
8

PRESSURE TEST

The Rapid injector is used as a pressure test point.
1. Connect the pressure gauge to the Rapid
2. Examine the supply pressure by turning the
3. Turn the taps off and disconnect the pressure
4. Make sure that all burners work correctly.
CHECKING THE HOB BURNERS
1. Lift the lid.
2. Put on the burner crowns and caps. Make sure
3. Put on the pan supports.
4. Light one of the hob burners.
5. Turn the knob for the hob to the off position.
CHECKING THE OVEN BURNERS
E
1. Put in the deep pan and the trivet.
2. Light the oven burner.
D
3. Turn the knob to the off position.
C

ELECTRICAL INSTALLATION

This appliance is supplied with a main plug and a
main cable.
Dimension
A
B
C
D
E
injector.
Rapid burner and one other burner fully on, and
lighting them. The pressure must be 20 mbar
for Natural Gas.
gauge.
that they are correctly seated.
To light the hob burner refer to the "Ignition of
the hob burners".
Check if the flame is regular.
Check each of the burners.
To light the oven burner refer to the "Ignition of
the oven burners".
Check if the flame is regular.
WARNING! The manufacturer is not
responsible if you do not follow the
safety precautions from Safety
chapters.
mm
250
680
50
250
580