Nikon PROSTAFF 7 Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Binóculos Nikon PROSTAFF 7. Nikon PROSTAFF 7 41 páginas.
Também para Nikon PROSTAFF 7: Manual de instruções (20 páginas)

Imprimir página

Internal display

Horizontal Distance display mode

First Target Priority mode

Distant Target Priority mode

『

』 - Aim at the target you want to measure. Position the target at the center of the reticle.

『

』 - Appears while the laser is being irradiated for a measurement.

Remains present during single measurement. Blinks during continuous measurements.

Do not look into the objective lens while this mark is shown.

『』 - Now measuring

『

』 - "Failure to measure" or "Unable to measure"

* Usually, an LCD employs equal or lower magnification. However the LCD of this product is magnified

by the high magnification of the eyepiece. Although this LCD was produced using the most advanced

technology, it is impossible to eliminate dust completely. As a result, dust may be seen. It will not,

however, affect measurement accuracy or safety during use.

Distance

Unit of measure (m/yd.)

Target mark

Laser irradiation mark

Battery condition

Measurement display mode

Press and hold the MODE button, then immediately depress the POWER ON/Measurement button (less

than 2 seconds) to change the mode in the order shown below.

Horizontal Distance

Mode

Actual Distance

Mode

1. Turn on the power (Confirm the internal display is on).

2. Press and hold the MODE button, then immediately (less than 0.5 second) depress

the POWER ON/Measurement button for less than 2 seconds.

3. Release your finger from the POWER ON/Measurement button to switch the

Measurement display mode.

* If the buttons are not pressed in the correct order, switching will not take place.

* Switching the mode after measurement converts the results to the new mode.

* After the mode is set, measurements are performed in the new mode.

Horizontal Distance

Actual Distance