ARO 7236-C Manual do operador - Página 7

Procurar online ou descarregar pdf Manual do operador para Moedor ARO 7236-C. ARO 7236-C 12 páginas. “22” series short grinders

MOTOR SECTION

M10

DISASSEMBLY

Remove motor from housing (see page 6). Grasp cylinder in one

race of bearing. Assemble cylinder over rotor, aligning air inlets of

hand and tap threaded end of rotor with a soft face hammer; motor

cylinder and end plate and roll pin (Y17B-20) with hole in end

will come apart.

plate (largest hole). Assemble blades to rotor - straight side out.

Assemble spacer (30437) and end plate (30432) to rotor, press-

ASSEMBLY

ing on inner race of bearing.

NOTE: Pack bearings with ARO 33153 grease and coat i.d. of cyl-

Be sure rotor does not bind (if rotor binds, tap threaded end lightly

inder with ARO 29665 spindle oil upon assembly.

to loosen) and assemble collet body (41752) to rotor. Assemble

Assemble bearings into end plates, pressing on outer race of

motor and spacer (30440) into housing and secure with head sec-

bearings. Assemble end plate (30129) to rotor, pressing on inner

tion.

MOTOR ASS'Y NO. R.P.M. ROTOR NO. BLADE NO. BLADE QUANTITY

37510-1

18,000

30435-l

41520

41389-3

14,500

32374-l

41520

NOT

INCLUDED WITH MOTOR ASS'Y

#INCLUDED

WITH CYLINDER 30972

PARTS MARKED THUS ARE INCLUDED IN SERVICE

KIT NO. 40102-l. SEE PAGE 9.