ARO GV08A-06S-7 Manual do operador
Procurar online ou descarregar pdf Manual do operador para Ferramenta eléctrica ARO GV08A-06S-7. ARO GV08A-06S-7 12 páginas. Sanders/polishers
SECTION
MANUAL
Ml0
174
I
Tool & Hoist Products
INCLUDING: OPERATION, INSTALLATION & MAlNTENANCE
Released:
4-30-94
Revised:
4-30-94
MODELS GV08A-03S-7,
GV08A-05S-7,
and GV08A-06S-7
SANDERS
MODEL GV08A-02P-7
POLISHER
IMPORTANT
SAFETY INFORMATION
ENCLOSED.
READ THIS MANUAL
BEFORE OPERATING
TOOL.
FAILURE TO OBSERVE
THE FOLLOWING
WARNINGS
COULD RESULT IN INJURY.
.
Always operate, inspect and maintain this tool in
accordance with American National Standards
Institute Safety Code for Portable Air Tools
.
(ANSI Bl86.1).
.
For safety, top performance, and maximum
.
durability of parts, operate this tool at 90 psig
(6.2 bar/620 kPa) maximum air pressure at the
inlet with 3/8" (10 mm) inside diameter air supply
.
hose.
.
Air powered tools can vibrate in use. Vibration,
.
repetitive motions or uncomfortable positions may
be harmful to your hands and arms. Stop using
.
any tool if discomfort, tingling feeling or pain
occurs. Seek medical advice before resuming use.
.
.
Always turn off the air supply and disconnect the
air supply hose before installing, removing or
.
adjusting any accessory on this tool, or before
performing any maintenance on this tool.
Keep hands, loose clothing and long hair away
from rotating end of tool.
Anticipate and be alert for sudden changes in
motion during start up and operation of any power
tool.
Check for excessive speed and vibration before
operating.
Tool accessory may continue to rotate briefly after
throttle is released.
Do not lubricate tools with flammable or volatile
liquids such as kerosene, diesel or jet fuel.
Do not remove any labels. Replace any damaged
label.
Use accessories recommended by ARO Tool.
The use of other than genuine ARO Tool replacement parts may result in safety hazards, decreased tool performance,
and increased maintenance, and may invalidate all warranties.
ARO Tool is not responsible for customer modification of tools for applications on which ARO Tool was not consulted.
Repairs should be made only by authorized trained personnel. Consult your nearest ARO Tool Authorized Servicenter.
It is the responsibility of the employer to place the information in this manual into the hands of the
operator.
For parts and service information,
contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand
Distribution
Center,
White House, TN at PH: (615) 672-0321,
FAX: (615) 672-0601
ARO Tool & Hoist Products
Ingersoll-Rand Company
© Ingersoll-Rand
Company 1994
Printed in U.S.A.
Part of worldwide
Ingersoll-Rand