ARO PG087A-A5 Manual do operador - Página 3

Procurar online ou descarregar pdf Manual do operador para Ferramenta eléctrica ARO PG087A-A5. ARO PG087A-A5 16 páginas. Impulse wrench

Imprimir página

ADJUSTMENTS

10.

Using a 1.5 mm hex wrench, rotate the Torque

Adjustment Screw clockwise until the Screw

stops. Rotate the Screw counterclockwise until it stops

or makes six complete revolutions.

Using the special Tee Wrench furnished in the Tool Kit

(Part No. l00PQ-99), remove the Oil Plug and

Oil Plug Seal.

With the oil plug opening downward over a container,

rotate the Drive Shaft to purge the fluid from the

mechanism.

Using the syringe and fluid from the Fluid

Replacement Kit (Part No. EQ106S-K400), fill the

mechanism with the fluid furnished in the Kit.

See Dwg. TPD1265.

DO NOT SUBSTITUTE- ANY OTHER FLUID.

Failure to use the fluid provided could damage the

tool, increase maintenance and decrease

performance. Use only clean fluid in these tools.

11. Submerge the fill opening in the remainder of the

fluid, and using a wrench, rotate the Drive Shaft to

purge any remaining air from the system.

12.

13.

14.

15.

16.

17.

Thread the Oil Plug with the Oil Plug Seal into the

mechanism until it is snug.

Using a 1.5 mm hex wrench, turn the Torque

Adjustment Screw clockwise until it stops. This is the

maximum torque position.

Wipe the outside of the mechanism dry and clean and

remove the Oil Chamber Plug. Using the syringe,

withdraw 0.25 cc of fluid.

Install the Oil Chamber Plug and tighten it between 20

and 25 in-lb (2.3 and 2.8 Nm) torque.

Insert the mechanism assembly, output end leading,

into the Mechanism Cover clamped in the vise jaws.

Insert the hex end of the rotor shaft into the hex recess

at the rear of the Drive Shaft and thread the assembled

Motor Housing onto the Mechanism Cover. This is a

left-hand

thread.

Rotate the Housing

counterclockwise

to tighten it. See Dwg. TPD1266.

COUNTERCLOCKWISE

TO TIGHTEN

(Dwg. TPD1265)

(Dwg. TPD1266)