Aerial AD 510 Manual de instruções - Página 9
Procurar online ou descarregar pdf Manual de instruções para Secador Aerial AD 510. Aerial AD 510 18 páginas. Condensation dryer
Instruction manual condensation dryer AD 530 / AD 630 / AD 630F
The automatic circuit breaker
of the building disturbs the
voltage supply to the device.
The fan of the dryer is out of
operation
It occurs an unusual, strong
noise formation
The complete dryer is out of
operation
That dehumidifier is frozen at
the evaporator very strong.
You can see an ice block.
from serie July 2003
5
The safeguard of the
building is too weak.
6
A malfunction in the
electrical circuit of the dryer
is available.
7
The dryer is in the defrost
mode
8
The filter holder is not
correctly inserted
9
One or several case screws
are not tightened correctly.
10
The dryer is switched off
11
The humidity adjusted at the
hygrostat is achieved.
12
The water tank is full
13
There is defective at the
device
14
The room temperature is or
was lower than +3°C for a
time.
15
There is a defective at the
automatic defrost system
page 8
AERIAL GmbH
The building safeguard must be
checked and/or transposed.
The voltage supply of the dryer
must be disturbed. (Pull power
plug!) The defect must be
eliminated by an expert.
The fan starts again after some
minutes. If it does not start again,
the defect must be eliminated by
an expert.
The filter holder must be inserted
correctly
The slack case screws must be
tightened correctly.
Switch on the unit at on/off-switch
The dryer turns on automatically
after exceeding the adjusted
humidity again.
The water tank must be emptied
and put into the device back.
The defect must be eliminated by
an expert.
You might put the dryer into a
room with at least +10°C and wait
until the entire has thawed ice.
Turn on after this the device again
and it might let about 3 hours run.
If a new glacial block should form
itself, contact your supplier.
Otherwise make sure that the
device is only used in rooms, in
which +3°C being at least.
Ice build-up is also possible after
too immediate switch-on after
storage in colder conditions.
The defect must be eliminated by
an expert.