Altronics Micron T 2445 Instruções de utilização - Página 2

Procurar online ou descarregar pdf Instruções de utilização para Ferramenta eléctrica Altronics Micron T 2445. Altronics Micron T 2445 3 páginas.

30W Micron Soldering Iron

CAUTION:

DO NOT WORK ON LIVE CIRCUITS

Before working on any mains powered equipment, make sure that it is turned off, and the mains plug

is removed from the power point. You must not undertake work on live parts.

DO NOT USE IF DAMAGED

If the power lead becomes damaged or seems faulty, discontinue use immediately. Seek the

assistance of an authorised service technician at the place of purchase to fix anything damaged.

HIGH TEMPERATURES

Soldering irons operate at high temperatures and can easily burn the skin and/or objects. Do not

touch the tip and heater at any time and keep it a safe distance from inflammable materials while the

unit is on, or while cooling after switching off. Please allow a sufficient time for it to cool before changing

tips.

MAINTENANCE AND GENERAL CLEANING:

If supply cord is damaged in anyway it must be replaced immediately, to avoid a hazard. Only a service

agent or suitably qualified person must carry out this work.

The iron may be cleaned with a damp cloth using small amounts of liquid detergent. Never submerse the

iron in liquid or allow any liquid to penetrate the case.

HOW TO SOLDER:

Prior to soldering remove any dirt, rust or paint on the part you wish to solder.

1. Heat the part with the soldering iron.

2. Apply rosin-based solder to the part and melt it with the soldering iron. Note: When using non-ros-

in-based solder, be sure to apply a soldering paste to the part before applying the solder.

3. Wait for the solder to cool and harden before moving the soldered part.

CAUTION:

• Handle the heated soldering iron with extreme care, as the high temperature of

the iron can cause fires or painful burns.

• The first time you use the soldering iron, It man smoke slightly as the heating ele-

ment dries out. This is normal and should only last for approx. 10 minutes.

• Never file the specially-plated tip.

TIP REPLACEMENT AND DRESSING:

Note: Tip replacement or cleaning should only be done when the iron is at room temperature.

The tip can be changed or replaced by unscrewing the knurled nut barrel assembly. It is essential that

the iron is switched off and allowed to cool before and after this operation, as damage may result if the

iron is left on without the tip inserted.

After removing the tip, blow out any remaining oxide dust that may have formed in the tip retaining area

of the barrel. Care should be taken to avoid getting dust in your eyes. Replace the tip and tighten the

knurled nut barrel assembly using only hand pressure. Pliers should only be used to tighten the nut if

loosening occurs when the iron is hot. Care should be taken not to over tighten the nut, as this may dam-

age the element.

T 2445

DO NOT FILE TIP