artisan TORO 3000 Manual de instruções e de peças sobressalentes - Página 8
Procurar online ou descarregar pdf Manual de instruções e de peças sobressalentes para Máquina de costura artisan TORO 3000. artisan TORO 3000 16 páginas. Extra heavy duty cylinder bed lockstitch compound needle feed walking foot stitching machines
Imprimir página
11.
12.
1. The outside presser foot pressure is adjusted by
#
loosening nut
(3).
2. To increase the holding capacity of the Outside presser
#
foot, turn the regulator
(1) clockwise.
3. To reduce the holding pressure, turn the regulator
Counter-clockwise. Be care not to fully unscrew the
regulator. It is spring loaded and will "pop" out.
#
4.
Tighten the locking nut
(3).
#
The standard height of the presser foot regulator
(1)
from the casting to the top of the regulator screw
is about 5/8" to 3/4".
For Leather Stitching:
The Feed Dog of the TORO-3000 is smooth,
(without teeth).
The TORO-4000 R and TORO 4000 P use a
different system without a feed dog.
To adjust the height of the feed dog:
Either of the two methods are possible.
1. Open the bobbin case to reveal the feed dog attaching screw.
#
2. Loosen the screw
(4) and move the feed dog up or down as
required.
3. Re-tighten the fed dog attaching screw.
OR a second method is to do the following:
3. Loosen and remove the two screws and small springs
hold the oscillating shuttle/bobbin case in place.
4. Remove the shuttle race and bobbin case from the casting and
reveal the feed dog attaching screw.
5. Remove the Feed Dog attaching screw and Feed Dog to
install any of the following except the standard needle plate.
Slotted Needle Plate (A) #43332
Stirrup Needle Plate (B) #43333
Holster Needle Plate (C) #43334
Standard Needle Plate (D) #43337
8.
6.
#
(1) that
OSCILLATING SHUTTLE HOOK
SPACER #1thru 5
25.